Electronics Forum | Wed Aug 08 21:24:52 EDT 2001 | davef
First, not that it�s bad, but SM-782, the land pattern standard is a pretty far distance from a DFM check list. Now, if you�d said D-275 er more properly 222X, ama be twitchin� less. Second, your process should include two distinct elements: 1 Data
Electronics Forum | Thu Apr 01 09:10:55 EST 2004 | cyclopsn
We are currently using non clean paste and non clean flux in our manufacturing process. But recently our customer feedback that using a non clean process might cause flux blockage in via hole area and potentially might burn or explode the boards over
Electronics Forum | Thu Apr 01 22:06:58 EST 2004 | Ken
How high a voltage? TV products use hundreds of volts on the vertical and horizonatal sync circuits. Historically, these consumer products were NOT cleaned. For your situation, contact your paste supplier.
Electronics Forum | Sun Apr 04 10:20:26 EDT 2004 | cyclopsn
Hi Ken I'm not so sure about the voltage level but I'm dealing with backplane boards. Michael, Thanks for the information, I dont mind changing the process but I need to understand why I needed to do do. That is only my concern.
Electronics Forum | Fri Apr 02 00:16:18 EST 2004 | Mike Konrad
There is no shortage of reasons to clean your boards. Soldering or reflowing your boards leaves �stuff� on them. This �stuff� is normally corrosive and conductive (some fluxes / pastes are more corrosive / conductive than others). In either case,
Electronics Forum | Wed Nov 13 04:12:20 EST 2013 | hqew2013
Do you design or define PCB layouts? If so circuit board, what rules and checks do you have in place to make sure your results are... optimal? Over the years, I've created a PCB design checklist to keep me out of trouble. I share these nuggets with m
Electronics Forum | Thu Sep 17 08:23:03 EDT 1998 | Wayne Carlson
I need an evaluation process to prove to a customer that our no-clean process does not leave excessive residue? Any ideas?
Electronics Forum | Tue Mar 07 21:19:50 EST 2000 | Van Hoang Dinh
I have few problems below, 1.I had problem with clean glue stencil at the midle of the process and after the process. 2.Very hard to Fix the bridging on the (close pin) connectors through the wave. Anyone can help on this. Thanks Van
Electronics Forum | Tue Mar 07 21:19:50 EST 2000 | Van Hoang Dinh
I have few problems below, 1.I had problem with clean glue stencil at the midle of the process and after the process. 2.Very hard to Fix the bridging on the (close pin) connectors through the wave. Anyone can help on this. Thanks Van
Electronics Forum | Mon Jun 04 07:38:26 EDT 2001 | hussman
Ummm...Ok? Lumidor, The best thing to do is find out at which process this "wax" is occurring at. Targeting the process that just changed may be presumptuous on your part. Pick up the phone or make a visit. In either case, you're the customer a
winsouce.jpg)