Electronics Forum | Fri Oct 13 07:25:48 EDT 2000 | yeo
Any one have any experience on solder fillet problem on 0603 chip capacitor ? The phenomenon is solder wetting on one terminal is very good and totally no solder wetting on the other terminal. The positing of capacitor is right at the centre of the
Electronics Forum | Mon Jul 16 10:44:29 EDT 2007 | Jacky
Hi All, Recently, we encountered strange defect at our SMT line. We can see solder ball spatter around at one of the component pad. This lead to insufficient solder defect at 1 side of the component. The other side of the component look good(Meet
Electronics Forum | Mon Jul 16 11:25:22 EDT 2007 | davef
For the problem part, describe the pads on the board and the aperatures on the stencil.
Electronics Forum | Thu Apr 19 02:49:07 EDT 2007 | ray
I observed some black dot or some oxidation occured on chip termination on pcba reflowed fews weeks ago as buffer stock. The solder joint and fillet wetting is good and shinning. It is an acceptable or defect condition per IPC standard/requirement? W
Electronics Forum | Mon Jul 16 16:42:40 EDT 2007 | pnguyvu
Hi Jacky, It seems you have solder bead problem, beading occurs when the solder paste brick splatter as a component is placed into it, after reflow, the splatter becomes a spherical solder ball. Hope this will help. Steve USA STENCILS
Electronics Forum | Fri Jul 20 16:39:18 EDT 2007 | john_smith
Jacky, we have had a similar problem. We needed to go to a smaller nozzle and also check your vacuume system and air kiss.Could be after placement when the machine blows air to insure the part is off the nozzle that it is effecting the solder brick.
Electronics Forum | Tue Jan 29 17:11:32 EST 2019 | slthomas
Your product is Class 3, correct? Otherwise, a clearly wetted connection is all you need.
Electronics Forum | Wed Jan 30 03:01:39 EST 2019 | robl
You could use a stepped stencil around the parts you're having issues with to add a greater paste deposit to them and not the rest, or slightly elongate the apertures and overprint, but this may lead to solder balling.
Electronics Forum | Wed Jan 30 13:17:22 EST 2019 | slthomas
In addition to robl's suggestions, I would look at the footprint on the board to make sure it meets the recommended dimensions. Abnormal layouts, particularly when pads extend under the component too far, can be problematic both by lifting the part
Electronics Forum | Tue Jan 29 08:21:50 EST 2019 | electronics101
Hi All, Can someone please help, I have a number of tall surface mount components that according to IPC 610 (8.2.2.3) are a fail due to the end termination not wetting at least 0.5mm + solder height. The components are very well soldered but the sol
