Electronics Forum | Wed Feb 28 00:01:47 EST 2007 | Muhammad Haris
Hi, The distance between the two terminations/endings/pads of 0603 (0201)is 0.15mm i.e. lesser than than the distance between the 0603 and through hole i.e. 0.5mm My ques is that, then why its termination doesnot short as it has a minimum distance.A
Electronics Forum | Mon Oct 22 20:41:32 EDT 2007 | jkhiew
Hi Dave, The solder has tended to wet the component termination of Ag/Pd (chip capacitor) but has not wetted the pads, whereas the solder has wetted both termination & pads when using Ag/Ni/Sn finishes. Thks
Electronics Forum | Wed Apr 18 04:22:43 EDT 2007 | ray
I facing dewetting problem on Ag/Pd termination(chip component)during reflow process. The solder wetting is pull to terminal side and exhibits dewetting. Any one ever face the same problem and any solutions for the problem?
Electronics Forum | Wed Apr 18 08:14:20 EDT 2007 | davef
Silver palladium termination * AgPd-terminated capacitors are designed for conductive adhesion. Reflow or wave soldering is not recommended. [EPCOS Multilayer ceramic capacitors, Soldering directions, October 2006] * CONDUCTIVE EPOXY BONDING. Epoxy c
Electronics Forum | Sun Apr 19 11:19:52 EDT 2020 | davef
A-610G 7.5.16 Components with Bottom Thermal Plane Terminations (D-Pak) says: 100% wetting to land in the end-joint contact area. Is that what you're asking about? Regards, David Fish [davef] Technical Editor & Customer Advocate
Electronics Forum | Thu Mar 26 11:25:21 EST 1998 | Earl Moon
In December and January (1997 & 1998) a number of people requested information regarding component cracking. I overlooked this until recently thinking design and process requirements were violated. After reviewing the last 14 months consulting effort
Electronics Forum | Tue Jan 29 08:21:50 EST 2019 | electronics101
Hi All, Can someone please help, I have a number of tall surface mount components that according to IPC 610 (8.2.2.3) are a fail due to the end termination not wetting at least 0.5mm + solder height. The components are very well soldered but the sol
Electronics Forum | Thu Dec 06 23:34:25 EST 2001 | Beny
Pls. help. I�ve problem with non-wetting defect at capacitor termination. I have faced this problem at the 2 kinds of termination. One is chip capacitor 0603 that its outer termination surface composed with 100 Sn (Lead free) and another one is Sta
Electronics Forum | Mon Dec 10 04:15:01 EST 2001 | Beny
Thanks for your advise Now I don't found Non-wetting defect at TIN COATED 0603 after I had increased peak temp and Time above 183 C. At film caps, I still found Non-wetting in high rate at film chip size 2416. I using PANASONIC's part with identif
Electronics Forum | Wed Aug 25 15:47:25 EDT 1999 | JohnW
| | | | | Could use a little help here. Can anyone clarify to me the cause and fix of chip caps/resistors tombstoning following reflow? | | | | | | | | | | Any help would be appreciated. Thanks. | | | | | | | | | Most common reason is uneven hea