Electronics Forum | Mon Jun 19 21:32:15 EDT 2000 | Dave F
Frank: Good luck on finding a specification. The right combination of material properties will greatly improve the lifetime of your flip chip component. Your flip chip supplier might be best starting place to determine underfill properties that ma
Electronics Forum | Sun Oct 09 22:07:51 EDT 2016 | geniepro
I would like to ask after glue bonding is abalibity drop. I test by force equipment that it is very difficult to drop after reflow 2. Very due by DIP machine. I check after Dip many chip drop. I wonder the glue not qualify I am using IR 130. Could yo
Electronics Forum | Thu Dec 07 19:54:55 EST 2006 | davef
We agree with "guest" above. This a "chip bonder" type material used to improve the reliability of array type devices. "A relative comparison of the N50 values is given below: No underfill = 1.0X (baseline) Corner bond = 1.3X Non reworkable underfi
Electronics Forum | Mon Sep 08 11:54:42 EDT 2014 | gregp
Hello Spoilt... Yes it's true about the kitting being important but we also offer a component tester/verifier option for our system. The components can be tested for each insertion if you wish. The machine will not allow a component to be inserted
Electronics Forum | Wed Sep 12 18:11:03 EDT 2001 | davef
First, what on the area array package are you analyzing � * Package cracking? * Cracked solder balls? * Er, what? Second, most failure analysis discussions consider dye penetration to be a non-destructive test, but then again most failure analysis
Electronics Forum | Wed Jun 13 03:37:06 EDT 2001 | ianchan
Hi mates, I did a recent shear test (destructive test), on a uBGA liken product, and noted the post-shear solder joint, had clean "smooth" visual appearance under the uBGA pad, however the matching pcb pad was clearly lifted clean. Question: 1) how
Electronics Forum | Mon Aug 27 15:02:45 EDT 2001 | davef
It�s uncommon to test green strength. [Whatever �green strength� is. Some chip bonder adhesive suppliers have taken to taking about improvements in �green strength� their literature. We have asked sales types to quantify this and have never heard
Electronics Forum | Fri Aug 08 12:46:02 EDT 2003 | davef
When I was a salty old fart in the Navy, we sent the babes from the turnip patch off on snipe hunts. Shear tests are [in my opinion] senseless. The shear stress you measure depends more on the shear rate and on the point where the force is applied
Electronics Forum | Thu May 06 11:37:48 EDT 2010 | davef
There is no specification. Shear tests are very material / operator dependent. BALL SHEAR TESTING OF RAW BGA DEVICES: A total of 3 devices were subjected to ball shear testing. Results of the testing indicated shear values in the range of 0.7-1.25
Electronics Forum | Fri May 14 11:24:00 EDT 1999 | Chrys Shea
| Looking for a reasonably priced portable device to do strength test(shear/twist)on glue cured Cap/Res. Any suggestions? Thanks | My torque watch came from Waters Manufacturing, Inc. A div of Talley Industries. Longfellow Center, Wayland Mas
