Electronics Forum | Mon Jan 12 18:06:38 EST 2004 | Kris
Hi, Is there any standard for voids in a leaded device or a chip component ? IPC 7095 lists maximum allowable voiding for BGA devices but has no information on leaded devices Appreciate your help- thanks
Electronics Forum | Fri Dec 03 12:17:18 EST 2004 | Dreamsniper
Hi, I was told that there is a reliability problem with a 30 to 50 percent champagne voiding on chip components. What is this? first time I've heard this terminology. can you help me? regards,
Electronics Forum | Tue Jan 13 22:07:42 EST 2004 | davef
No, there is no such information. Choices are: * Recognize that any voiding is a process indicator and that when observed, indicate a requirement for taking corrective steps. * Tell your quality people to quit looking at components other than BGA wi
Electronics Forum | Wed Jan 14 08:45:04 EST 2004 | Kris
Thanks Dave Will appreciate if any body has any published information on a study they did for voids in leaded devices Will try to talk to them Dave
Electronics Forum | Mon Jan 19 18:49:42 EST 2004 | menglong
we are facing the same problem,and we are looking for some research result about voids.who can help to provide these ones ? any suggestion, pls keep me informed contact me :zhanglg@tpv.com.cn
Electronics Forum | Fri Jan 23 10:39:35 EST 2004 | patrickbruneel
Kris, I assume with voids you mean acceptable solder coverage of pad and lead. As Dave mentioned I also have not seen any specific studies on voids, but workman ship standards exist about acceptable coverage of pad and lead (both consumer and MIL)
Electronics Forum | Tue Jan 19 10:27:33 EST 2021 | grahamcooper22
Anyone experience high voiding levels in SMT lead free solder joints when the CHIP has bright tin plated end caps ? In the same process, Matte tin plated CHIPs don't show any voiding issues.
Electronics Forum | Fri Jan 22 13:22:18 EST 2021 | davidhillman
Hi Graham - brite acid tin gets it "shiny" appearance due to codeposited organic material in the tin plating. The codeposited materials volatilize during the soldering process causing a ton of voids. Brite acid tin plating should not be used as a sol
Electronics Forum | Fri Aug 10 04:19:05 EDT 2001 | wister
There are lots of voids at solder joint of chips,the thickness of multilayer pcb is 3.2mm,top side have lots of chip component and bottom side has several BGA and QFPs.For top side profile,the preheat time is about 100s,soak time is about 75s,time ov
Electronics Forum | Sun Dec 10 11:55:16 EST 2000 | Bob Willis
The following may be of interest to you. INTRODUCTION TO X-RAY INSPECTION All text Copyright Bob Willis, EPS INTRODUCTION TO X-RAY INSPECTION The use of X-ray inspection is becoming very popular due to the increased use of Ball Grid Array (BGA)
