Electronics Forum | Fri Jul 10 07:34:00 EDT 2020 | elijah
From the poor bonding strength of the board, the surface quality problems of the board are divided into: 1. The cleanliness of the board surface; 2. The problem of micro graphite (or surface energy) on the surface. PCB circuit board proofing Youke bo
Electronics Forum | Fri Sep 13 14:33:32 EDT 2002 | Simon
Thanks to all of you. This is very kind. I'll have a good poke around the circuit board for loose / hot components - good tips. I think it might be a throw away job, but I thought I'd give it a last try. You guys have actually given me much more
Electronics Forum | Fri Sep 13 13:26:34 EDT 2002 | dougt
If it's not blowing the fuse in the car then I guess it wasn't drawing a huge amount of current. Check the power wires going into the radio and look for something loose. My first guess is your loosing voltage across a bad connection somewhere and a
Electronics Forum | Mon Sep 16 12:56:56 EDT 2002 | dragonslayr
simon- davef is on the right track. 1st year electronics courses teaches us that you should always check the power supply first. In this case, the power supply in question is not your power source but the regulated power within the unit. I suspect o
Electronics Forum | Thu Jun 15 07:20:23 EDT 2006 | William G.
How are your experiences with stencilling 0201 components on large circuit boards, i.e. 400 * 250 mm ? Will there not be too much mismatch between between stencil and (FR4) boards? If so, would dispensing be a solution? Any other solutions?
Electronics Forum | Sun Apr 28 07:34:34 EDT 2002 | hany_khoga
Dear Tom : I hope I �m not too late. We produce PC motherboards with some buses exceeding the speed of 100MHz . we use no clean flux and it is OK even with the residues you can see under a microscope. But according to our own experience through a mo
Electronics Forum | Wed Aug 25 00:10:13 EDT 2021 | sarason
The company that does this is McDermid. There are multiple different ways of doing it. Screen print silver paste onto the mylar, "activate" the film to be conductive, then plate in copper. These processes are found in the patent literature which is e
Electronics Forum | Tue Sep 16 13:06:18 EDT 2014 | jacky3855
Our company is one of leading Electronics components distributor.We sale IC(Integrated Circuit),Modules,Capacitor,Connectors etc, If you need any goods,please email to us Yours Sincerely Brenda HongDa Electronics Co.,Ltd http://www.ic-hongda.com
Electronics Forum | Fri Jul 07 11:06:44 EDT 2000 | John O'Brien
You ought to consider Data Matrix directly marked on the boards It can be done with laser, inkjet, or other permanent marking methods. Never falls off, can be read even if 30% is obliterated. For an example, check any AMD (K6, K7) or Intel Pentium c
Electronics Forum | Mon Jul 03 14:47:35 EDT 2000 | Ashok Dhawan
In a typical flowline assembly of circuit boards, what are the different methods used for tracking WIP ? I can think of : 1. travel cards - not suitable for panelised boards 2. Marking ID# on board at various operations while board is being built.
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
winsouce.jpg)
