Electronics Forum | Thu Oct 02 18:53:36 EDT 2003 | Michael Nguyen
We are using a Trek board washing system with 2 deionizer tanks hooked up to the 2 final rinse tanks and the first tank is directly connected with the city water. We are having problems with a vendor board on some tranformer/chokes. The part manufact
Electronics Forum | Sat Oct 04 00:21:00 EDT 2003 | Dean
It would help to run a carbon, anion, cation, mixed-bed configuration with pure DI as the final rinse. IF your incomming water is really bad you can run a RO unit to "prepare" the water for ion exchange. Do you run omega meter or ionograph testing
Electronics Forum | Fri Oct 03 01:03:15 EDT 2003 | Truett H.
I would discourage the use of city water at all - where rinsing electronic parts is concerned, it contains too much contamination. If practical, route DI water to your first tank and implement some aggitation (either nitrogen bubbles from the bottom
Electronics Forum | Thu Oct 02 21:00:26 EDT 2003 | davef
Who says the chlorine comes from your tap water? Our PTOW dumps boat loads of chlorine into our water periodically. Sometimes it's so bad you can smell it. We doubt that it is the source of your problem. This chlorine will volitize very quickly,
Electronics Forum | Thu Oct 23 23:38:48 EDT 2008 | pathakvj
We have 8 layer HASL PCB. We saw molten solder blobs / balls on op side of assembled PCB. (to check, if this was a bare board problem), We passed bare board as received thru, SMT reflow oven and saw solder balls on top side of board. What could be th
Electronics Forum | Mon Oct 27 14:15:47 EDT 2008 | hussman
So you passed a BARE board thru the oven and got solder balls?
Electronics Forum | Mon Oct 27 14:28:19 EDT 2008 | patrickbruneel
Do you refer to the highlight in the picture as a solderball? Looks more like copper to me.
Electronics Forum | Thu Oct 30 19:59:05 EDT 2008 | gregoryyork
solder ball was caused by hasl process not reflow. seen before many times, look around wells of smt on bare boards should be more of them
Electronics Forum | Fri Oct 24 06:55:48 EDT 2008 | clampron
Good Morning WS, If you experieced the solder balls after reflow of a bare board through the oven, then the source of the solder is either the oven or the board. I have had boards with untented via's that were HASL'd that had entrapped solder and fl
Electronics Forum | Tue Nov 04 12:58:17 EST 2008 | smt123
I have to agree with Patrick here. This image appears to show a board that is NOT HASL as there is what appears to be a copper pad in the upper portion of the image. But then again the arrow tip appears to be white and I woudl expect that to be red s
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
