Electronics Forum | Wed Aug 09 19:14:15 EDT 2006 | Board House
Our Manufacturing policy regarding welds is as follows. 1) Inner layers - depends on Core thickness and line width. Our shop will not do any welding on core thickness less then 5 mils. or line width less then 5 mil. Good AOI practices reduce the a
Electronics Forum | Thu Oct 05 16:48:41 EDT 2000 | LarryK
Has anyone ever used the circuit repair kits? The type where you can replace a PTH or SMT pad that has been lifted or damaged? It appears that you just select a pad, trace or whatever needs replacing from a panel and heat or glue it onto the board.
Electronics Forum | Fri Oct 06 08:00:41 EDT 2000 | jackofalltrades
We use both, old boards and repair kits with equal success. Contact East (http://www.contacteast.com/) has a nice selection of kits depending on your needs, beginner v.s. experienced.
Electronics Forum | Thu Oct 05 17:05:36 EDT 2000 | JAX
These types of foil kits work just fine as long as they are used before expiration. Scraping off the epoxy coat gets a little tough on fine pitch pads and etches. I have always like to use a solder sample board to retrieve my bits & pieces from whene
Electronics Forum | Mon Apr 17 19:44:20 EDT 2000 | Dave F
Ashok: Well, your customer probably has a good reason for wanting you to send them boards without holes in the solder mask. What is their goal for the mask capabilities after you get do reworking the boards? * Cosmetic surface coat? * Performance t
Electronics Forum | Wed Nov 13 22:30:05 EST 2002 | davef
Methods for performing repairs: * 7721 - Repair & Modification of Printed Boards & Electronic Assemblies. * On-line guides at Circuit Repair Technology [ http://www.circuittechctr.com ] site. Roughly from East to West, service companies that perfor
Electronics Forum | Thu Jul 22 15:15:24 EDT 2004 | russ
You can purchase pad repair kits at some "radio shack" type stores or you can order them from some such as Circuit repair corp. If you know where the signal traces go from the individual connector pins I woul;d recommend just adding a wire frm the p
Electronics Forum | Thu Mar 14 17:10:22 EST 2002 | stepheno
I've been looking at buying a trace repair kit. The one I'm looking at includes some nifty little bits for a dremel or whatever. What I was wondering is, if someone is going to cut traces with a dremel, would you reccommend getting the stand for it
Electronics Forum | Fri Mar 15 15:11:08 EST 2002 | clarkk
Check out http://www.circuittechctr.com/index.htm They have kits and training for making pcb mods. And no, I don't work for them. But they have saved my butt once or twice with handy repairs for damaged pcb's. Good luck!
Electronics Forum | Thu Jul 07 07:09:16 EDT 2016 | soldertools
BEST is an IPC Master Certification Solder Training Center offering Instructor and Operator courses for IPC-A-610, IPC J-STD-001, IPC/WHMA-620, IPC-A-600, IPC-6012 and IPC 7711/7721. BEST is also known world widely for PCB repair kits and materials t
Midwest Circuit Technology provides Carbide Router Bits and End Milling Cuters for use in PCB Depaneling equipment. We have over 35 years of supplying tools and machining experience in drilling, Routing, Test Fixture manufacture.
114 Barrington Town Square
Aurora, OH USA
Phone: 13309956900
winsouce.jpg)