Electronics Forum | Wed May 25 19:04:39 EDT 2005 | russ
check your clamping rails and see if you see any little wear marks, we constantly hit these clamps during placement when the parts are too close to the edge. The height of that clamp is either 4 or 6mm I beleive and the noozles will hit them on occ
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Fri Feb 29 08:27:34 EST 2008 | tbkonrad
This morning I turned on our Qsv-1 and ai resiveved the following error. "Clamp did not open: House Air pressure may be lower then 70 psi" after checking the Air Pressure it reads at 80 psi on the Main air pressure gauge as well as the 80 psi on the
Electronics Forum | Thu Dec 16 06:06:52 EST 1999 | Stefan
Check the print gap and check the clamp edges, sometimes the clamps is damaged causing a distance between the PCB and the screen. Good luck
Electronics Forum | Mon Sep 17 09:44:29 EDT 2001 | gresko
Dave, Ceramic sheets of that size are not always flat and as a result will sometimes crack when clamped along the full edge. Point clamping will hold the substrate secure for placement. If you are not processing in a pallet make sure that you have
Electronics Forum | Wed Nov 13 23:50:23 EST 2002 | iman
we changed our top/bottom clamping system in the Printer, to a side-edge clamping system. This removed the higher paste issue similar to your thread.
Electronics Forum | Thu Aug 07 11:17:51 EDT 2003 | 51165
Can someone help me with a Ref Side Clamp Mesh Error on a CP643E?
Electronics Forum | Wed May 25 19:11:49 EDT 2005 | jsloot
That I can do, checking the placement height that is and the clamps. I believe my clamps are 4mm. If your nozzles have survived 5 years how many placements is that...roughly? In the billions?
Electronics Forum | Thu Apr 06 18:31:27 EDT 2006 | jsloot
Any one familiar with a board clamp problem on MPM UP3000? The one I have will not clamp the board when program is running. It will work when toggled through the output diagnostics. Any help is appreciated.
Electronics Forum | Tue Jan 23 13:15:44 EST 2007 | stepheniii
Shouldn't the top of the board be at the exact same height as the top of the side clamps? Why are the clamps holding the stencil up off the board?
winsouce.jpg)