Electronics Forum | Mon Apr 13 18:18:31 EDT 2020 | wbrenner
Does any one have a general cost percent going from class 2 to class 3 for the same Assembly.. Or, general up charge percent when biding class 2 vs class 3?
Electronics Forum | Thu Aug 07 22:51:05 EDT 2008 | davef
We expect aerospace to be IPC-A-610, Class 3 and J-STD-001, Class 3. The above quality statement stecifies: * "IPC 610, Class 2 acceptability." This is unclear. Should this be "IPC-A-610, Class 2 acceptability?" * No class for J-STD-001. Should we a
Electronics Forum | Mon May 04 10:06:49 EDT 2020 | davef
Some Class 3 customers don't want their products to be comingled in assembly processes with Class 2 products.
Electronics Forum | Fri Aug 08 18:20:23 EDT 2008 | arminski
DAVEF, THANKS. I was told that the verbage "unless otherwise specified by customer" should be enough to cover for Class 3....hmmmm also i was told that it was written so because the company's major customers are in Class 2 products that's why it h
Electronics Forum | Thu Feb 05 14:30:29 EST 2015 | chsravan
Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB?
Electronics Forum | Tue Dec 30 09:31:52 EST 2014 | rgduval
I've always approached it like this: Design your processes and perform your work to class three standards, and inspect to the standard that is acceptable. That is, all work should be performed to the highest degree of quality. When the work is ins
Electronics Forum | Fri May 27 14:09:19 EDT 2022 | davef
No solder mask; Class 2 => Class T; Class 3 => Class H.
Electronics Forum | Tue Apr 14 08:58:45 EDT 2020 | emeto
Charge them double
Electronics Forum | Tue Jan 06 13:26:47 EST 2015 | rgduval
I can't say I've ever heard that you shouldn't rework class 3 products. Since class 3 and class 2 are inherently inspection standards, rework might be required to meet class 3 specs. In the past, that has been an issue, as everyone wants to produce
Electronics Forum | Fri Feb 06 11:11:04 EST 2015 | mascott123
I have asked that same question to a co-chair of the J-STD-001 committee who in turn checked with personnel at IPC. The answer I received is that yes you can apply the Class 3 assembly requirements using a class 2 PWB but the resultant assembly will