Electronics Forum | Mon Apr 01 20:10:24 EST 2002 | davef
Oh. [Howabout if I smack you?] If ahma connectin� wif whut yer sayin�, you: * Don�t like the appearance of the glue slobberin� out from under the component even though there is no apparent glue on solderable surfaces. * Concerned about the hydrosco
Electronics Forum | Mon Jul 26 14:14:51 EDT 1999 | Steve Gregory
| | | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is th
Electronics Forum | Mon Jan 22 22:37:27 EST 2001 | davef
50 ppm oxygen was on half joints reflowed in air. 3d Human factors PCB pad cleanliness: Handling of bare board pads creates excessive voiding. Print rejection: Cleaning of OSP pads with acetone or isopropanol increases voiding.
Electronics Forum | Tue Apr 13 11:41:18 EDT 2021 | jeremy_leaf
I have a SAC305 preform with which I am attempting to bond a gold coated component to an ENIG coated PCB pad. I've specified 2 microinches of gold for the ENIG. It worked previously but now with a new batch of boards, I am having an issue where the p
Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two
Electronics Forum | Fri Sep 17 21:25:00 EDT 1999 | Rob
| | HI everyone, | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 an
Electronics Forum | Fri Sep 17 23:59:40 EDT 1999 | JAX
| | | HI everyone, | | | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00
Electronics Forum | Wed Jun 11 16:30:33 EDT 2003 | T.Vick
You have received some great feedback so far. I would like to summarize and add a few points regarding maintenance. You should start (as recommended already) by verifying your component library data. Using the default values from the master library i
| 1 |
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)
.gif)
