Electronics Forum | Sat Jun 12 00:34:00 EDT 2004 | kanwal324
Hi ! The main problem being faced currently is formation of solder balls - to be precise, these are micro solder beads generally found attached with bodies of SOTs, Chip Caps, Chip Resistors, between pins of SOICs (50 mil) - lying on PCB surface,
Electronics Forum | Wed Dec 08 11:26:04 EST 2010 | davef
3 Printer Area Conditions * As stated earlier, heat and humidity are damaging to solder paste. Ideally, the printing area should be maintained at 40% - 50% relative humidity and 72°- 80°F (22-26°C). In addition, no air (cool or warm) should blow dire
Electronics Forum | Mon Jun 28 11:51:36 EDT 1999 | Brian Wycoff
| | | | Dear guys, | | | | | | | | I have some problem on assembling micro-BGA with solder paste (63/37). The micro-BGA we assmeble is 0.75mm pitch and with 45 pin (solder bump is 96.5/3.5Ag). The stencil is a laser-cut stencil with 5 mil thicknes
Electronics Forum | Wed Nov 09 02:24:49 EST 2005 | laxman
Hi Dave, Normally in our country (India) during rainy season the temperature will be 25to 30 �C and RH of 50 to 60%. The reason behind this humidity issue is that recently we have moved to our new facility with centralised air conditioner with Chill
Electronics Forum | Mon Oct 14 12:56:50 EDT 2002 | davef
His technical contribution to the forum. From these 24 postings, we can see that 75% of Sean�s postings have a decided commercial bent, as followings: * Could be argued that the posting is a good technical response. Percent of postings 25%. * Could
| 1 |
