Electronics Forum | Tue Apr 05 20:45:36 EDT 2022 | stephendo
Try adipic acid to clean your nozzles. It is a powder and can be awkward to work with as a result. But you might end up preferring it. Also look where the substance is not. There are two PTH joints without it. And that chip cap is closer to the PT
Electronics Forum | Fri Oct 27 11:48:59 EDT 2006 | stepheniii
I use adipic acid to clean our Ersa selective solder machine nozzles. Makes a huge difference and is quick and easy.
Electronics Forum | Mon Apr 29 13:56:19 EDT 2013 | williamaxler
We have a Versaflow 40/50 and ours is setup like this. We have out nozzle test position set so that in the Z axis you are 3.8mm away from the pin. Used feeler gauge Then you can set your gradient per nozzle. Start with a number then do a wave offs
Electronics Forum | Mon Apr 29 12:32:18 EDT 2013 | stephendo
Do you watch when it is doing the wave height test? Watch it and see if it goes up to the same spot on the test probe each time. If the test probe is dirty sometimes the solder has to go up higher on it before it gets detected. You might actually be
| 1 |
