Electronics Forum | Tue Jul 10 18:03:49 EDT 2001 | pzohbon
Does anyone have a recommendation for a cleaning solution used in an ultrasonic cleaner for cleaning RMA solder paste off stencils and adhesive off pcb boards. I am going to be evaluating Armakleen 2001, Zestron Vigon SC 200, and Aqueous Technologies
Electronics Forum | Wed Jul 11 20:20:44 EDT 2001 | davef
Your selections are good, assuming you are talking about cleaning raw paste, rather than reflowed RMA. Maybe add Multicore Prozone, JNJ Aquasonic, and Kyzen Aquanox.
Electronics Forum | Tue Jul 24 08:09:24 EDT 2001 | tommiller
I�m using Zestron's Vigon sc 200 in our ultrasonic cleaner. It works great for cleaning our adhevises and pastes (RMA and no clean) from stencils and misprinted PCBs. We used to use a saponifier which did a terrible cleaning job and was a real pain t
Electronics Forum | Wed Jul 11 18:42:35 EDT 2001 | Darby
As I mentioned in the previous string we are happy with Electrolube "SSS". The guy who built our ulrasonic cleaners recommended it and it works very well. You don't have to change tanks or machines for a switch from paste to adhesive. It doesn't leav
Electronics Forum | Tue Jul 24 12:48:45 EDT 2001 | kerryn
Can you tell me a little bit about the Zestron product. How many stencils do you clean and much Zestron do you use per month? What is the cost? Do you mix it with water? If so, what temperature? How do you get rid of the waste? Thanks. Kerry
Electronics Forum | Mon Jul 30 07:41:21 EDT 2001 | tommiller
5 stencils/day. Not sure of the cost, it is high, but I only use a little each month so it is cheaper than the 50+ gallons I was dumping out each month of the old stuff. Mix it with water and use at room temp (don�t have any eaters).Don�t create any
Electronics Forum | Sun Jul 15 17:48:51 EDT 2001 | kerryn
You should check the archives, there has been much written on this subject in the past. Asking about the correct chemistry is wise. It never ceases to amaze me how many people think ultrasonics will work without the proper chemistry. Without the rig
Electronics Forum | Mon Oct 16 20:50:34 EDT 2000 | Dave F
This is vague. What is causing ... When does it appear ... What is it's occurance ... What is the frquency ... What does it look ... What problems does it ... And on and ...
Electronics Forum | Mon Oct 23 14:05:08 EDT 2000 | Aokilab
Hi Soza: As Dave F mentioned, there are lot of factors involving the formation of residue, after cleaning. Factors, (such as: solvent's cleaning power, presence of metal oxides, type of soldering flux, etc...). One thing pretty sure, IPC is usually
Electronics Forum | Mon Oct 16 00:45:33 EDT 2000 | soza
Dear sir, I have a problem to find the new chemical solution instead IPA(isopropyl alcohol) to eliminate contamination on the test pin socket board made from copper that plate with nickle and gold. And after the often testing IC process, the co