Electronics Forum | Thu May 07 08:31:13 EDT 1998 | Alan Pestell
We are about to use BGAs on our equipment. We clean all products prior to confomally coating them - to keep moisture off the IC legs. Will this be a problem with BGAs. Will we need to get the coating underneath the BGA or will the pitch on the balls
Electronics Forum | Thu May 07 15:56:43 EDT 1998 | Terry Burnette
80ppm). The CTE of your board and solder joints will typically be 18-22ppm. We have seen cases were the coating fills the gap between the component and the board, then during temperature cycling the coating expands to the point of breaking the solder
Electronics Forum | Wed Aug 16 13:31:30 EDT 2006 | a_laser
You can stop cleaning after a job when there is no more paste in the apertures. Under wiping should be done with a quality cloth and should leave no paste on the underside of the stencil (assures good contact on the next print and reduces chances of
Electronics Forum | Thu Apr 11 19:12:11 EDT 2002 | djarvis
Sorry fellas -disagree. We only clean our stencils in the ultrasonic machine at the end of the run. If the same pcb is up the next day we clean them by hand. We use Electrolube SSS and the used rolls from the in line under stencil cleaner. Wipe the
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Wed Jan 30 21:56:47 EST 2008 | rayjr1491
On the DEK Horizon there are two options for underside cleaning one is a foam cleaner and paper cleaner that advances. The Foam cleaner cleans using liquid but does not increment and foam piece and can be washed but there are still contaminents. We h
Electronics Forum | Mon May 26 10:40:25 EDT 2008 | aj
Hi , The dirt you are seeing are fibres from the wave solder pallet. Clean the underside of the pallets aswell as cleaning the Pot. aj...
Electronics Forum | Tue May 19 12:29:59 EDT 1998 | Richard Jackson
| Richard, | You may be encountering solder paste contamination | on the assembly during the printing process. Solder | will reflow on tin/lead plated lands therefore invisible. | If you are washing the assembly prior to inspection | then you are
Electronics Forum | Mon May 18 21:29:38 EDT 1998 | D.Lange
| I've tried every thing I can think of. Do you have any | Ideas? | What I have is micro balls on the gold fingers of | panelize boards. These balls only appear on the gold | finger. Or at least I can only find them on the gold | fingers. | What I
.gif)
winsouce.jpg)