Electronics Forum | Wed Oct 01 15:24:55 EDT 2014 | horchak
are you trying to lengthen or shorten the lead length? Lengthening the amount of lead being cut off and going into the scrap tube will shorten the lead length. Lead length is pretty much determined by the down stop setting on the insertion head, the
Electronics Forum | Wed Nov 19 21:39:18 EST 2014 | gregp
Hi Spoilt...thanks for your reply. The latter part of your reply is a bit perplexing though. The CS-400E is easy to set up. There are two lights spots that indicate the insertion location. The component does not need to be prepped other than bent
Electronics Forum | Tue Aug 31 08:10:38 EDT 1999 | Brian Conner
| I am building a board with T1/34 LED's in a 10X10 array there are 12 arrays in a panel. The LED's are body to body in the array, .1 spaced. The LEDS have been autoinserted on a Universal RAD III, so they are cut and clinched. The trouble I am havin
Electronics Forum | Mon Jul 23 10:09:32 EDT 2007 | slthomas
(1) part standoff - how far the base of the part rests from the top of the board. Seating plane will rest flush with the board, whether it's the bottom of the part or a lead form. (2) lead length - is the final length of the lead adjustable, so t
Electronics Forum | Thu Oct 06 07:28:11 EDT 2005 | chunks
The obvious is size. Besides that, it depends on your screen printer. Some "smart heads" need to be retaught with the metal blades for each board. Some need to have the set-up programmed changed too. Angle of attack is something to double check a
Electronics Forum | Tue Dec 06 08:11:41 EST 2005 | lwright10
is the Chuck set correctly on the collers, Wide jaw Soft spring & Narrow jaw hard spring. Also check the pick up angle in the feeder file.
Electronics Forum | Thu Sep 25 17:37:54 EDT 2008 | gregoryyork
Best is 7 or 6.5D if you cant achieve 7. In fact this is the best angle for Leaded and Lead Free, so watch the Chinese machines as they come in around 5 and cause loads of bridging problems
Electronics Forum | Thu Sep 25 04:57:51 EDT 2008 | fnorradd
Hi All, I was wondering if any of you have any ideas on what is the optimum angle for the conveyor to pass over the waves on a leaded wave machine ? Any input would be greatly appriciated. Regards Darron
Electronics Forum | Fri Dec 12 10:00:57 EST 2008 | gregoryyork
Hi Patrick Yes we have some that you cant tell the difference. BUT machine set up and angle are extremely important with Lead Free as is the dosing alloy. Cheers Greg
Electronics Forum | Wed Nov 28 21:37:53 EST 2018 | lukejk95
Hello, so basically I've been having trouble with parts popping up as they are being inserted into the PCB. It happens at random and I've gone through multiple rebuilds and tons of adjustments and still cant get a clean run. I've tried raising the cu