Electronics Forum | Fri Jan 31 05:18:10 EST 2003 | reg
We have a customer who is going to be using the new Snapshot process. Has anyone used this process all ready. Who did you use to make the tooling etc. Was there any problems that arose during this process. The process involves screening balls into s
Electronics Forum | Wed Mar 17 19:57:08 EST 2004 | Dreamsniper
Do you wanna save the BGA or what? Do you have an electric stove, baking tray and a BBQ clip? Does your wife love cooking? if u have one of each, then u don't need a reflow oven which is too expensive and you don't need to buy heating guns or drill p
Electronics Forum | Mon Mar 06 10:54:22 EST 2006 | fredericksr
We have also had some of the same problems, but at the risk of sounding redundant, we have had success in using both the 8mm and 16mm tape clips to secure the tape. We have also been very pleased with the adjustable 16mm feeder doing a job the regul
Electronics Forum | Tue Feb 21 09:10:27 EST 2006 | gregp
To everyone who hates vibe feeders, Follow this link--http://www.contactsystems.com/C5.htm Scroll down and click on the video clip that says stick feeders. Yes, I work for Contact System--but this is such a great solution for tube parts. I consider
Electronics Forum | Tue Feb 28 12:20:31 EST 2006 | gregp
As far as I recall the Component Express is a copy of a prototype we showed around trade shows about 5 or 6 years ago. In the case of the Component Exress feeder basically you stick an air tube in the back of a stick. It is in no way comparable to
Electronics Forum | Tue May 09 08:46:43 EDT 2006 | eyryren
This is Shenzhen comofaje Tech.co.,Ltd from China mainland We are the Associator of Hi-tech industry Association, so I think we can become your supplier in China. Now we have Four series products:1 SMT stencil wiping roll/wiper special for FUJI MPM
Electronics Forum | Fri May 12 13:33:27 EDT 2006 | mika
...Ehhhh?? Mark Fick, If the SMT Splice Clips or Kapton tapes does not solve Your DEK-265 motor comms failure problem, maybe try this: The 5 Volts should be within +/- 0.05 V. and if I remember correctly it must Not be under 4.5 V. We have been th
Electronics Forum | Thu May 11 02:52:34 EDT 2006 | eyryren
We are the Associator of Hi-tech industry Association, so I think we can become your supplier in China. Now we have Four series products:1 SMT stencil wiping roll/wiper special for FUJI MPM DEK MINAMI YAMAHA SANYO and so on ,non woven wiper 2,kinds
Electronics Forum | Wed Jun 14 01:24:14 EDT 2006 | AR
Thanks ;) We even did some product development on that one. We took a normal bar of wave soldering alloy, sawed a suitable length off it and drilled a carefully measured hole through the bit of solder. The hole is wide enough so that the blister tap
Electronics Forum | Thu Sep 21 13:27:09 EDT 2006 | jimmyjames
We 'bend and clip' with good old fashioned needle nose pliers and side cutters. A typical size for a run would be 20-30 boards. Many of our designs are over a decade old and are fully TSO'd (FAA standard) and we can't change anything in the design.
