Electronics Forum | Mon Aug 31 06:26:44 EDT 2015 | piyakorn
Hi At our SMT mounting found battery clip stick in the reel pocket and some dropped under pick&place machine from the nozzle can not pick out the part which got recommendation should change the nozzle type from standard placement to be clip sho
Electronics Forum | Tue Mar 23 12:55:47 EST 1999 | Dave F
| I am looking for clip art images of electronics assembly. Images like wave soldering, surface mount components, soldering irons... just general assembly graphics. Many sites have different individual images that they use I was just wondering if a
Electronics Forum | Tue Oct 19 14:51:27 EDT 1999 | Kiet Dang
I'm trying to set up a SPC for a thermo compression beam lead attach process. We're using a west bonder thermo compression machine. I'd appreciate any input on temperature, pressure,tool, and critical process considerations. thanks, -kiet.
Electronics Forum | Wed Aug 28 10:16:12 EDT 2002 | Jim M.
Sam We install a lot of die in the SMT room using same process as SMT parts.Water soluble solder paste is used for attachment of die to ceramic and boards. Biggest problem i found is the adjustment from installing the die in the bonding area. The t
Electronics Forum | Thu Oct 11 13:37:35 EDT 2001 | Stefan
The pressure sensitive tape is used as an alternative to heat sealed cover tape. It works usually quite well and is easily applied by the taping machine, but it can create some problems in the tape feeder. In the Surftape, Cal is referring to, the c
Electronics Forum | Wed Dec 11 02:03:59 EST 2013 | haiae
I did not find anywhere in the software or button to do dry run mode, but I see one video clip in the youtube that show this machine can do it.
Electronics Forum | Thu May 30 17:17:42 EDT 2013 | andrew88
These systems normally use pneumatic suction cups, attached to a plotter-like device to allow the nozzle head to be accurately manipulated in three dimensions.
Electronics Forum | Tue Mar 22 14:50:11 EDT 2016 | ttheis
A friend of mine has a used gsm1 but when loading up UPS it gives an error indicating it did not receive a request to load the machine model in the allotted time. Photo is attached of the message. Any suggestions what to look at? The machine is runni
Electronics Forum | Fri Jan 29 18:47:35 EST 2021 | ilavu
The error in the attached picture(FCFF1043) is for 16 I/O card located in CIO slot one for board transfer. May be thats when your PDP supply drop voltage. If problem comes back, look at that card and/or connection and/or cable.
Electronics Forum | Fri Jan 29 13:25:43 EST 2021 | ttheis
Update: I have replaced both dc-dc converters without any improvement. Observing the issue again yesterday I was able to see more of the problem. Logicomm reported a bus error at fcff1043 running "butt" (photo attached.) The DC power ligh
