Electronics Forum | Fri Jul 13 12:21:41 EDT 2018 | emeto
The right way in your case is to use shield with cover. Place, reflow, remove shield pick up rails/tabs, AOI, close cover.
Electronics Forum | Mon Sep 20 13:55:37 EDT 2010 | jamyboy
Check to make sure that the front and back of the DEK265GSX covers are closed. I have seen issues where the back cover trips its interlock and people go other places to look for the problem.....hope this helps
Electronics Forum | Fri Sep 18 05:10:07 EDT 2015 | bobpan
Hello Simon, I would check to make sure the covers are closed and the cover switches are working. Make sure an e-stop is not pressed. After that....I would check the contactors in the rear of the machine. I have had the contacts on the insides of som
Electronics Forum | Mon Jun 10 08:13:48 EDT 2013 | bobpan
Check to make sure the side covers are closed. It is probably an interlock problem. Also if you have carts...make sure the plunger switches are down. Good Luck
Electronics Forum | Wed Apr 30 16:00:12 EDT 2008 | tech13108
Hello, We have recently purchased an older MPM via auction and I am trying to get it running but not getting too far. When I power it up it goes thru a boot sequence then a screen appears on the monitor with a "warning cover not closed, close cov
Electronics Forum | Thu Sep 05 22:33:28 EDT 2013 | davef
It depends: * If you're talking jars, I'd be as conservative as possible. So, 3 days from when the jar is removed from the frig would be my pot life limit. * If you're talking Semco cartridges, I'd be talking about 10 days from when the cartridge is
Electronics Forum | Thu Apr 02 21:25:16 EDT 2009 | davef
On Orbel E-Z SHIELD, Surface mount two-piece fence and cover: Make the pads 1:1 with the pads on the fence. On Autosplice MINI 7-V2004-115 RFI Clip floating: * Autosplice recommended pad small dimension is very close to the small dimension of the pa
Electronics Forum | Mon Sep 20 14:11:39 EDT 2010 | dman97
Yes I have checked both covers and they are both closed. The latch keys are sitting in their respective slots. I need to know how I can lower the hood manually or if there is a way to get into the diagnostics menu before the machine boots. Thanks.
Electronics Forum | Wed Mar 13 17:17:42 EDT 2013 | isd_jwendell
I don't know your machine, but on mine the interlock is the large access door. It's done so that you cannot open the cover while running, but it also checks for a closed door at startup due to head homing sequence. Yours may be similar in that it won
Electronics Forum | Mon Jan 15 11:12:08 EST 2007 | jaimebc
I've had experienced this issues here with our GSM's Flex heads. Try this: 1.- Clean your linear scales with alcohol and a lint free cloth. Both the X and Y. This one has fixed the majority of our errors when one of the heads just stops for no apare
