Electronics Forum | Fri Jun 22 11:02:13 EDT 2007 | gregf912
I have a CP642E machine that will not function if auto adjust is enabled in Part Descriptor. Symptom: Auto pick offset causes machine to pick part off center to the point of going to end of part after several picks. This only happens to parts that ha
Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Fri Sep 20 12:32:46 EDT 2002 | cyber_wolf
Can anyone tell me where I might be able to find parts for the vision system on our AP25 printer. In particular I am looking for the cable(s) that go from the camera to the Cognex card. Thanks
Electronics Forum | Thu Jul 15 09:21:10 EDT 2004 | adlsmt
Does anyone have a diagram showing which driver cards do what in the back lower drawer of an AP-20? Or at least which one drives the camera?
Electronics Forum | Fri Sep 09 03:51:57 EDT 2005 | geb
Thanks for your help. Yes it is a VME630 Lantern vision system. I'll try swapping the card with the one in the other machine.
Electronics Forum | Sun Jan 29 11:54:06 EST 2006 | johnw
Hi Dax you want to run a cal card with good cad data on all machines then take the results and then alter the placement xy data to pull all machines into calibration. But make sure all the cameras are calibrated and the pam results are good and withi
Electronics Forum | Thu Aug 04 11:38:53 EDT 2011 | emeto
If you think it might be connected to Video card or RAM you can put a PC with better parameters. In my case the application dies with a standard Windows message.In the beginning I would blame the camera, but after that I realized it is doing it when
Electronics Forum | Fri Oct 04 13:14:13 EDT 2019 | ddfreeze
I need to access the calibration menu, does anyone have a password for it? having issues with the z axis hardware limit. doesn't appear the card is bad. board raises to camera and goes back down???
Electronics Forum | Sun Aug 28 23:53:58 EDT 2016 | aemery
I don't think there is a camera off message in the software, but I might be wrong. So I am making a bit of an assumption here that you didn't have a displayed image and your error was a fiducial not found error. I am also wondering if you decided to
Electronics Forum | Thu Sep 08 11:56:37 EDT 2005 | siverts
I have seen this before. Sounds like that You are having problem with the vision box, located in the rear left of the machine; that is if you are using the old vision system, the newer Lantern vision card is located in the VME chassi in lower front r
