Electronics Forum | Wed May 15 05:44:04 EDT 2019 | peterchan
1、YSVJ-650B three-group multi- blades cutting machine, multiple sets of tools run at the same time, split the whole piece at one time, greatly improve production efficiency; multiple sets of tool design ensure that the split plate effect is not defor
Electronics Forum | Fri Dec 08 16:54:42 EST 2006 | flipit
My experience with SMT LED packages is that certain LED package styles tend to float. This floating is caused because the LED is often only terminated on the bottom side of the LED package. Sometimes the LEDs are terminated like a SMT resistor with
Electronics Forum | Fri Aug 18 11:26:08 EDT 2006 | Board House
Hi Mark, Couterbore is possible in two way's during PCB Manufacturing. Couterbore plated and non-plated. Meaning that the entire hole will either have to be Plated or Non-Plated. Prefered Methode is Plated, to accomplish this your PCB house would
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Wed Aug 03 12:18:49 EDT 2016 | dekhead
You don't say what kind of printers you are running, but if you had multiple light sources and independent control of direct an oblique lighting (either manual and software controlled) usually pretty "do-able". I have customer doing almost exclusivel
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Thu Jul 25 14:18:34 EDT 2019 | babe7362000
It's been awhile but I was wondering if anyone knows how to read the LED's on the Tep board to what they mean. Top 4 Red 1. blinking red 2. lit red 3. off 4. lit red 5. lit red 1. blinking green 2. not lit 3. lit green 4. off 5. off On the Gui
Electronics Forum | Thu Aug 08 11:04:48 EDT 2019 | btfonseca
Hi everyone, I was recently trying to troubleshoot a bad floppy driver on our QSV-1, which actually worked, I was able to read floppy drives but for some reason it all went downhill when one of the green LED's turned off and another red LED turned on
Electronics Forum | Thu Jul 05 20:54:27 EDT 2012 | actioncontrols
Hello: We have used our Phillips Topaz on a number of volume jobs and been very pleased. A while ago it became apparent that the vision LED's were growing dimmer as evidenced by having to adjust light intensities upward for various components in so
