Electronics Forum | Wed Jan 26 05:24:56 EST 2005 | SLVito
Morning All, I have to choice between two axial through hole machines: Panasert AVK 3 and Universal VCD Sequencer 8. I will insert axial components with 0,45 mm to 0,8 mm component lead diameter and perform jumper wire insertion in the same machine.
Electronics Forum | Wed Jan 26 08:27:12 EST 2005 | pr
I am using the AVK and am VERY pleased with it. One thing to keep in mind is incoming tape and reel has to be pretty exact. The parts are going into a feeder and if the width varies too much you'll have problems. After we got control of Tape and reel
Electronics Forum | Wed Jul 24 22:20:30 EDT 2002 | mantis
we have 3 Rad 8's and never use the verifer cause its too bloody slow.Why bother u cant verify parts being placed on a chip shooter so if your operator takes the same care when loading a reel there should be no need to verify.
Electronics Forum | Mon Feb 21 17:56:44 EST 2005 | davef
You want approximately 5 particles minimum across the smallest aperture. So in the case of a 0.8mm device, we use .017" pads with a round 0.020" aperture on a 6 thou thick stencil foils. Here, 0.020" diameter equals 0.50mm. This gives us 0.50/5=10
Electronics Forum | Tue Oct 26 10:49:00 EDT 2004 | Simon UK
Hi, > > I'm planning to get a new oven. I wanna > know the advantages and disadvantages of each > oven type over each other. I'm being told to go > for an 8 zone oven. > > thanks for your > help. > > regards, Depends really if you want a dua
Electronics Forum | Sat Sep 12 10:47:00 EDT 1998 | Jon Medernach
I am aware that the Intel processor is available in a 0.012" leadframe, as a TAB product ( which can be excised and placed with may P&P machines but I do not know of any 0.008" leadframes, Bumped Die are at these pitches and frankly I would bet dime
Electronics Forum | Thu Sep 10 17:10:00 EDT 1998 | Steve Gregory
Hi Tim, 8-mil huh? Boy, that's getting down there...you know, placing 8-mil is one thing, but printing solder paste on 8-mil pitch is another. Most of the time when I've seen 8-mil pitch on a board it's been attached with hot-bar...but I guess
Electronics Forum | Wed Jan 01 13:03:06 EST 2020 | ramsus
hello experts i want to calculate my target of cph i have a panasonic line composed of three machines 1.CM602L 4 HEADS 12 SHAFT 2.CM602L 4 HEADS 12 SHAFT 3. CM602L 2 HEADS 8 SHAFT + 2 HEADS 3 SHAFT Best regards
Electronics Forum | Tue Jun 11 15:56:43 EDT 2002 | mjabure
Actually F4G is a programming environment similar to panatools, not a machine, it stands for "Fuji 4th Generation". The connection being questioned is to the communication network, and yes with the proper hardware you should be able to connect more t
Electronics Forum | Sat Jun 08 22:18:28 EDT 2002 | liuguoyu
Now I have a set of F4G system,4 CP742E and 8 QP341,how do I connect them?
