Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Tue Nov 10 19:31:09 EST 2020 | mikewschomisch
I have been able to manually enter CMOS info in SETUP thanks to suggestions from this forum and get past the CMOS and EEPROM failures. Now stuck "diskette error". Any key will produce the same message. Thanks.
Electronics Forum | Sun Jun 08 16:31:02 EDT 2014 | ipdisplays
Prob totally screwed the pooch... Got more than a little frustrated with not being able to get the stupid software to do what I thought it should do, anyway figured maybe the IEC port was the problem - I have a couple of spare cpu cards, so I swapped
Electronics Forum | Fri Apr 05 01:52:57 EDT 2024 | ddfreeze
Samsung SM321 machine fails to initialize when booting software. I have swapped PCI and communication boards, all resulting the same, I replaced the CMOS battery on communications board, tested the voltage on the backplane, and reloaded the software
Electronics Forum | Wed Nov 11 03:36:10 EST 2020 | dekhead
Assuming you have defined HDD correctly (this is a non-standard CMOS setting), unless it is a totally dead HDD not the normal error for HDD failure. More inclined to think a CPU issue, I have not seen a "bad EEPROM" on that machine before... but pres
Electronics Forum | Tue May 26 23:42:20 EDT 2020 | smiran082
Hello, I am having trouble the QSV-1 PNP machine. On boot it had trouble connecting to the RT computer as it was hung on a message saying something along the lines of, "Establishing connection to RT computer". After several restarts we still could
Electronics Forum | Tue Nov 10 21:00:41 EST 2020 | mikewschomisch
I removed the ribbon cable from the FDD and edited the setting in SETUP to "NOT Installed";. Came back with 'Diskette drive failure on drive A'. on reboot. Still shows "Diskette error" on last line. Possible HDD issue? Thanks.
Electronics Forum | Fri Feb 09 01:46:55 EST 2024 | erikfriesen
I have a 2005 DEK Horizon 02i, the cmos batt was dead, so I replaced, and reset the bios. The device hangs in initialization, eventually erroring out. The vision led's blink rapidly during this period. Also, the card shows an error in device manag
Electronics Forum | Thu Dec 11 02:24:37 EST 2014 | vladicac
We found out what was the problem. If you happen to get the same error be sure to check if you have access to all COM ports. Also check CMOS battery. Because of low battery voltage all BIOS settings were lost. Because of that we had to reconfigure ou
Electronics Forum | Tue Oct 26 17:30:36 EDT 2021 | dilogic
Messages indicate bad battery on EPC-5 CPU board, not SYS68K CPU-30. You have to fix that first. What kind of hard disk is installed? EPC-5 boards support small disk sizes, so sometimes , if larger disk is used, users "trim" reported capacity to lowe
