Electronics Forum | Thu Oct 30 21:06:20 EDT 2008 | ashley
Hello mickd, For Fuji practice, the primary tooling hole preferably be 5mm from the edge of the PCB (lower right hand corner). This is the reference X0, Y0 co-ordinates in the Fuji program where placing co-ordinates going LEFT will be -ve value & go
Electronics Forum | Tue Jun 14 07:33:58 EDT 2005 | bobpan
If the placement is off the same amount everytime...(which I suspect it will be)...just adjust your placement co-ordinate for the part and be done with it.
Electronics Forum | Tue Aug 03 03:13:17 EDT 2004 | V.R.Kini
Bent nozzle can result in vaccum leakage resulting in parts falling during part pick up. Correct this. However, if your machine has laser/vision alignment, you should not be having a problem since these come in to picture after pick up. If you have a
Electronics Forum | Thu Nov 03 09:43:55 EST 2005 | lupo
Check flux penetration and type of flux. How much is solid contents. The solder filling is better under Nitrogen. Check the time (speed) of the nozzle whether is correct. Usually For SAC305 the temperature of bath is 320C/degrees, but only for sel
Electronics Forum | Tue Jan 09 08:26:51 EST 2007 | stepheniii
If your boards are not totally rectangular part of the board can stick out past the stopper. If the fiducial is there then you can't use it. Also make sure you are not using panel fiducial co-ordinates and then expanding those out with panelization
Electronics Forum | Sun Jun 07 19:16:54 EDT 2015 | linux
Hello everyone, I'm looking for help with placement issue on our cp6 Fuji. On occasion we have to adjust co ordinates on the x and y axis usually about 0.12mm. Ball screw was replaced did not fix issue. Anything else we could try. Thanks everyone
Electronics Forum | Thu Sep 05 08:33:54 EDT 2019 | bobpan
Make sure your placement rotation co-ordinates are correct. If you do a function 3 it will show you. I think they should be in multiples of 6000....ex...6000 = 90 deg. Also check the z axis number. I dont think its cyber or vac related. It is somet
Electronics Forum | Tue Mar 15 17:47:24 EDT 2022 | guyt
Hi, Has anyone had a issue with a MyData my12 dual camera system, were the calibration always shifts up after a few hours of use. It's not the mechanical calibration. it is like the machine loses it's software calibration co-ordinates ?? Any ideas
Electronics Forum | Thu May 02 14:58:20 EDT 2013 | stephendo
Kurtz had a guy that was great with the machine. I strongly suggest that you watch the wave height test a few times in the morning then at lunch and at the end of the day. Look where the solder goes up to on the probe. If it doesn't work consistent
Electronics Forum | Fri Dec 05 05:02:27 EST 2014 | sarason
When I was a younger man with a younger mans eyes it was easy to outplace a hand placement machine. Good hand eye co-ordination is all that is required now I would find it easier to use the machine , but my fine motor skills are still just as good. A
