Electronics Forum | Sat Aug 07 02:28:20 EDT 2010 | raghu
We have PVA 350 benchtop dispensing equipement with humiseal 1A33 CC material. is there any moisture measurement process in conformal coating material?
Electronics Forum | Thu Sep 10 17:13:31 EDT 2015 | tombstonesmt
There are factors that manufacturers have taken into consideration when dealing with coating. On/off times, dispense speeds, heights, etc.. Dedicated software with tools to easily map out paths are a godsend. We made our own coating machine with a s
Electronics Forum | Tue Oct 31 19:28:24 EDT 2023 | ttheis
We built our own coating system by mounting a Universal Robots UR5 to an edge conveyor between a magazine unloader and magazine loader. The robot has a needle dispenser on the head. We chose a needle dispense process to avoid aerosols and complex ven
Electronics Forum | Thu Sep 20 03:31:42 EDT 2018 | minhhaioh34
Hi all, I need some pro help me with issue bubbles after coating. some information for some pro: Machine: Asymtek Chemical: Achime AVR80 Oven: IA 4 zoon4 ( setting 100 100 90 80 conveyor speed: 0.6 m/min). I had happened before and after the oven. W
Electronics Forum | Tue Oct 12 15:00:42 EDT 2004 | jdumont
Ok, so as it turns out our vendor may be buying us the dispensing system to you on their product. Any suggestions now for a system in the 25K range....things are looking up!
Electronics Forum | Fri Jul 01 20:12:16 EDT 2005 | Tom B
Steve, We use that Circuit Works pen as well! You can purchase a UV cure then download it to an opaque syringe or bottle. Use a small EFD or similar luer lock tip and dispense where needed. Tom
Electronics Forum | Wed May 16 08:48:14 EDT 2018 | charliedci
Looking for anyone that is familiar with Assymtek coating, 2004 model C-718, running on Windows NT. We experienced the blue screen of death (cannot find dll), had IT recover programming, install another hard drive in PC but now manual control of disp
Electronics Forum | Wed Mar 04 10:59:24 EST 2015 | jpierre
Hi first DS65 version is a specific dilution for dispensing machine, in this case the typical process is following: application of the conformal coating extraction of solvent (low extraction power is better)2minutes and drying the drying can be done
Electronics Forum | Fri Sep 11 12:08:10 EDT 2015 | derrikf
I built one using an old Asymtek Automove. When all was said and done, it cost less than $400, including what was paid for the machine itself. It's a very basic setup, (air over syringe), but for our needs it does everything and more. With air to syr
Electronics Forum | Thu Nov 19 05:18:37 EST 2009 | prodivegsr
Hi All, Recently we are working on the conformal coating process using Humiseal chemical 1B73 and thinner 521. Bubbles on component body/joints are seen after gone through the IR Reflow Oven. During the conformal coating, only tiny bubbles seen af
.png)
