Electronics Forum | Fri Nov 15 11:12:15 EST 2002 | V.RAMANAND KINI
I have tried this white s/m coating. I want some thing better. I am looking at a metal frame cover over the PCB or leave the PCB surface with HAL avoiding soldermask. Will this HAL withstand -40 to +85 deg?
Electronics Forum | Sat Jan 23 07:08:54 EST 1999 | Graham Naisbitt
| I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the c
Electronics Forum | Wed Jan 27 09:00:56 EST 1999 | Chris Fontaine
| | I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the
Electronics Forum | Thu May 26 09:54:49 EDT 2016 | swag
Not exactly SMT but something I recently did that might save you lots of time and money: Complex high $ assy that has 25+ conformal coat keep out areas - most different shapes. All locations are dimensioned on customers' print. We tried a one piec
Electronics Forum | Thu May 26 12:00:21 EDT 2016 | swag
Yes - the frame is built to nominal per print then the tape pieces are placed into areas in the frame as required. I had the stencil house cut #'s into the frames designating each different size. When I cut the tape pieces, I put them on a large, s
Electronics Forum | Thu May 26 11:58:35 EDT 2016 | tombstonesmt
Is the frame placed on assembly as a guide to install the masking tape?
Electronics Forum | Wed May 04 11:54:29 EDT 2005 | HOSS
Rob, Are you hinting that the lead content of this component with dipped tin/lead solder would not be an issue with RoHS? If so, our understanding is that the legislation requires that the 6 banned substances cannot exist at greater than X% in any
Electronics Forum | Tue Sep 30 20:05:34 EDT 2003 | afm
Does alloy 42 lead frame on a QFP100 make lack of coplanarity (let's say 2 mils), a critical factor to have non-wetted leads? Lead coating is tin lead 90/10. afm
Electronics Forum | Thu Sep 07 11:39:39 EDT 2017 | swag
Two magic bullets help us greatly with fine pitch printing: 1) nano coatings (we use a DEK product) YES it really does work 2) temperature control in the printer (AC unit). Of course good quality stencil and proper cleaning of the stencil are im
Electronics Forum | Fri Jul 24 13:04:55 EDT 1998 | Dave F
| Hey youse guyz... | We're finally getting our first real job at the start-up I'm working at. It's actually a pretty unique little board too. Simple as all get out, but unique. You're not gonna believe what this goes into...guess? (I bet ya' you'll
winsouce.jpg)