Electronics Forum | Mon Jun 25 12:23:15 EDT 2007 | coax
As for the bubbles/fisheyes, try increasing your thinner ratio. This sounds like your coating is thickening up before you are able to apply it to your application.
Electronics Forum | Sat May 07 07:03:16 EDT 2011 | jimlas53
Thanks for the suggestion, Bobpan. I'll start looking for a replacement coax cable. Would we be better off to look for a Quadalign system and replace the Cyberoptic unit? Doug
Electronics Forum | Fri Sep 10 15:15:09 EDT 2021 | majdi4
Hello to all , Could you help with this defect .. Tombstoning 0201 , always at the same place in board , only this component near to the coax connector..with a defect rate of 2 % ..All the process is perfect . i cheked : stencil design , SPI resul
Electronics Forum | Thu Jan 14 22:52:28 EST 1999 | Wayne
I am experiencing a problem with a surface mount coax connector that over time pulls loose from the PWB. The connector has 4 small gold plated leads and we are soldering it to a flash gold board. A cable plugs into the connector and puts some const
Electronics Forum | Mon May 14 12:44:08 EDT 2012 | tomgervascio
I am a user of an Ersa Versaflow 3/45. I was wondering if anyone could share some process pointers. I have a 0.125" multilayer PCB that I am having problems consistently achieving 75 percent hole fill on a mini-coax connector. The coax connector ha
Electronics Forum | Mon Sep 02 15:20:48 EDT 2013 | aemery
Interesting! not the usual error. In my experience when the vision cables get damaged it shows up and white noise flashes across the monitor. The connections are the easiest to check so here's your system layout with connection points. Starting at
Electronics Forum | Fri Apr 05 13:42:05 EST 2002 | dougt
We have been using a silicone encapsulated, high flex, flat cable for a short time now and have not been succusfull in terminating it to connectors with shell housings designed for round cable. Our solution thus far has been to leave the housing off
Electronics Forum | Thu Jan 14 23:38:34 EST 1999 | Chris G.
| I am experiencing a problem with a surface mount coax connector that over time pulls loose from the PWB. The connector has 4 small gold plated leads and we are soldering it to a flash gold board. A cable plugs into the connector and puts some con
Electronics Forum | Fri Jan 15 11:40:37 EST 1999 | Bob Willis
| | I am experiencing a problem with a surface mount coax connector that over time pulls loose from the PWB. The connector has 4 small gold plated leads and we are soldering it to a flash gold board. A cable plugs into the connector and puts some c
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
| 1 |
