Electronics Forum | Thu Jan 21 03:09:05 EST 2010 | aungthura
I have tried to solder sockets by reflow machine. but, failed because sockets were deformed after reflow.Has anyone had some advise for me?
Electronics Forum | Fri Jan 22 08:25:18 EST 2010 | davef
This socket supplier never expected you to do what you're doing to his/her part. Some materials bear-up under the thermal strain of reflow solder than others. Try different socket materials.
Electronics Forum | Mon Jan 25 04:25:49 EST 2010 | aungthura
Thanks Davf that socket we couldn't change since the customers supply these sockets.we can contro only our process.
Electronics Forum | Thu Jan 28 13:23:18 EST 2010 | plerma
i agree, with the other fellow, check the data sheet for the part and see what it can handle otherwise hand assemble.
Electronics Forum | Fri Oct 08 11:48:23 EDT 1999 | Jim Prestridge
I'm searching for a source for surface mount socket savers that accept a hand test socket (Yamaichi, Nepenthe etc...). Barring availibity of an SMT socket saver does anyone know a good technique for soldering socket savers into a .250" thick, 20+ lay
Electronics Forum | Fri Oct 17 06:44:32 EDT 2014 | hemant_pang23
We are doing hand soldering for the 'BATTERY LITHIUM COIN CELL 3V CR 2032 but now we want do the soldering through wave soldering process ,for avoiding the shortckt only one pin will get solder through wave process and other pin will be soldered manu
Electronics Forum | Fri Oct 17 09:31:21 EDT 2014 | rgduval
To be honest, I have never had success wave soldering or reflow soldering batteries, regardless of their intended use. If you're going to continue a manual operation to solder one pin, I'd suggest that you just solder the entire component in by ha
Electronics Forum | Fri Oct 17 15:23:28 EDT 2014 | davef
First, don't exceed the maximum temperature of the battery, say 85*C [I don't know your specifics] Second, don't short the terminals of the battery. Third, the best way to wave solder a battery is: * Insert an insulating tab between the battery an
Electronics Forum | Tue Oct 27 03:22:43 EDT 2015 | pvogel
I'm looking for some SMD shims or something to solve this problem. We have a coin cell on a PCB and the side that contacts the PCB also has traces under the cell that don't connect to the cell. So I'm after some small dots of something suitable for
Electronics Forum | Sun Oct 10 00:40:42 EDT 1999 | John
| I'm searching for a source for surface mount socket savers that accept a hand test socket (Yamaichi, Nepenthe etc...). Barring availibity of an SMT socket saver does anyone know a good technique for soldering socket savers into a .250" thick, 20+ l
winsouce.jpg)