Electronics Forum | Fri Jul 21 13:34:54 EDT 2006 | fredericksr
hot/cold slump, print misregistration
Electronics Forum | Wed Aug 22 02:01:03 EDT 2007 | lococost
Have you tried the same setup with your leaded paste? Your lf paste might have different cold slump characteristics.
Electronics Forum | Wed Aug 21 13:28:20 EDT 2019 | ameenullakhan
And what is the solder paste selection recommendation for the same. 1. Water soluble ( organic based flux solder based ) 2. No clean ( rosin or resin based solder paste ) customer is suggesting water soluble chemistry , which is having lot hot an
Electronics Forum | Mon Aug 23 03:12:57 EDT 2010 | grahamcooper22
Possible route causes of bridging on fine pitch ICs are; too much paste (stencil aperture wrong), poor print quality (paste smudges during printing), pcb pads not flat depending on the solderable coating, paste has poor cold slump properties, too muc
Electronics Forum | Mon Sep 17 15:27:51 EDT 2001 | jschake
Challenges: The basic defects that impact assembly yield are bridging, satellite solder balls, and opens (i.e. tombstones / draw bridges). There are many variables with the stencil printing process that can impact these; several of them are listed
Electronics Forum | Tue Nov 28 21:16:17 EST 2006 | davef
J Rose at EMPF says: The introduction of no-clean solder fluxes in electronics manufacturing has given rise to greater levels of solder balling simply because the opportunity to remove them in the wash process does not exist. They are typically cause
Electronics Forum | Mon Jan 15 06:18:50 EST 2007 | CL
Good Morning Stephen, 1) Most solder paste manufacturers recommend a 2 hour temperature stabilazation period. Solder paste should not be opened and exposed to ambient air if it is still cold. 2)Manufacturers do not reccomend mixing old and new paste
Electronics Forum | Wed Oct 03 23:58:23 EDT 2018 | gaintstar
Flason SMT News: http://www.flason-smt.com/new/6-Things-to-Check-Before-Submitting-Your-PCB-Design-for-Manufacturing.html http://www.flason-smt.com/new/about-wave-soldering-machine-tin-pot.html http://www.flason-smt.com/new/Advantages-of-Design-for-
| 1 |
