Electronics Forum | Thu May 09 12:06:06 EDT 2013 | pbarton
We run Zipatec 460's also. I presume that you are running Nitrogen? We have found that if the Nitrogen flow rate is too high into the conical nozzle collar it can be sufficient to disrupt the smooth flow of the solder as it runs down the wettable o
Electronics Forum | Tue Jun 05 14:28:02 EDT 2007 | realchunks
Hi Stephen, So are you guys talking from a facilities standpoint that a cold solder pot saves enery on your AC? If so, Corvettes are cool as long as you drive with a popped collar. WML riding a Huffy = LOL!
Electronics Forum | Thu Mar 06 14:06:50 EST 2008 | realchunks
Some guy who things he's cool cause he drives a Vette whilst his collar is up.
Electronics Forum | Thu Mar 06 14:34:16 EST 2008 | srmlan
I have not had problems with ENiG panels, but they were made state side. We had Trace Labs cross-section them and found no problems. Whats this about yellow nails? Mine are full of grease from constantly having to fix the Jeep. I would try to pop my
Electronics Forum | Wed Jun 27 14:23:20 EDT 2001 | Claude_Couture
I just fell off my chair laughing, reading the above... If I may add my two cents, I would give the customer the option of remote controlled collars for the operators. When they are too slow or make a mistake, ZAP! short burst of high voltage... Sam
Electronics Forum | Tue Oct 19 10:53:14 EDT 1999 | Carol Zhang
Hi, I tried to use high temperature solder (540 - 570F)to connect four spacers on the board. The solder mask around the spacers wrinkled a lot.I can even see a few bulbs around it. I use hot plate and solder rings. After hot plate is heated to appr
Electronics Forum | Thu Aug 16 20:11:21 EDT 2001 | davef
Hussman is correct. Make those people quit. [Just walk-up, pimp slap 'em, grab their dental pick, and say "Dave says you can't use this any more. I'm just following orders."][Trust me, this is much smoother than the "Tonya Harding Approach" that I
Electronics Forum | Tue Jun 18 21:17:00 EDT 2002 | Todd
Gee Ken, the old cart business must really be slow, I see you commenting on any old item in the forum in an attempt to hawk your carts and how they improve efficient factory operation. I have read your white paper and found it very entertaining to se
Electronics Forum | Sun Jun 17 05:42:58 EDT 2007 | mika
Hi Shrek, I quote: " Well, whether your parents like it or not, I am an ogre! And guess what, princess Mika? That's not about to change. My background is that I�m a big, good looking guy that is used to gettin� my way with my wit and muscle." I don
Electronics Forum | Wed Aug 14 13:39:59 EDT 2013 | eadthem
Most of this you have probably covered, but these are what have caused heating issues for us in our 1707 EXL. First, you would probably notice, but check that all blowers are turning by looking at there cooling fans in the top and bottom, Our 170
.gif)
