Electronics Forum | Thu Aug 27 14:32:34 EDT 2020 | dekhead
Following a pressure error, if continue is pressed, the next print with THE CORRESPONDING squeegee should attempt to compensate by increase or decrease in pressure (as appropriate)... Is it: 1)Not changing at all? 2)Over compensating? 3)Under compens
Electronics Forum | Thu Aug 21 09:34:57 EDT 2003 | davef
Woa. The more paste that you put a a BGA ball, the more likely that you'll bridge between balls. Why do you need to compensate for the size variance in BGA balls? How does using a 8 thou thick stencil to compensate for ball size variance? Fine pi
Electronics Forum | Sun Jun 10 21:18:06 EDT 2001 | ianchan
Hi Guys, Thanks for the tips, will try it on next run. Regards, ianchan :)
Electronics Forum | Tue Jan 03 14:56:42 EST 2006 | DannyJ
endorsed=compensated... Amazing, get three days off, I need to be retrained!
Electronics Forum | Thu Aug 29 00:08:34 EDT 2013 | pradeep_selec
Thanks to all, Is there a natural way to compensate humidity.
Electronics Forum | Tue Sep 03 04:19:51 EDT 2013 | pradeep_selec
Can anybody suggest the way to compensate humidity if its out of range
Electronics Forum | Sat Jun 29 18:59:43 EDT 2019 | davef
You weren't clear on the type of gauge that you're using. Strain gauge load cells are the most common. These load cells have two gauges. The orientation of the gauges affects cell performance characteristics. * Temperature compensated: Temperature
Electronics Forum | Fri Jun 08 13:29:14 EDT 2001 | dougt
Local fiducials will help component placement but will have no effect on part recognition. Local fiducials help you compensate for board skew or streatch by looking at a small area of the board vs. the board fiducials that cover placement over the e
Electronics Forum | Tue Jun 12 09:30:42 EDT 2001 | Rob Fischer
I assume the material you are using is black. This may sound far fetched but try using a lighter color material. Going from black to gray has given users as much as fifteen degrees F. less in heat loss.
Electronics Forum | Tue Jun 12 11:28:30 EDT 2001 | CPI
Rob: Wouldn't that only apply to IR ovens. If using a true convection oven the color of the material wouldn't hinder output at all "Right". Don�t want to see someone spend money on new tooling if unnecessary.
