Electronics Forum | Thu Apr 09 17:13:23 EDT 1998 | Ryan J.
Has anybody heard of a shield to shield the cutter from flying leads during hand cutting of through hole components. If it collected the leads also that would be helpful. I am thinking of plexiglass or something that the board could be placed under.
Electronics Forum | Thu Apr 09 18:36:52 EDT 1998 | Steve Gregory
| Has anybody heard of a shield to shield the cutter from | flying leads during hand cutting of through hole components. | If it collected the leads also that would be helpful. | I am thinking of plexiglass or something that the board | could be plac
Electronics Forum | Thu Apr 09 18:02:03 EDT 1998 | Ron Beasley
| Has anybody heard of a shield to shield the cutter from | flying leads during hand cutting of through hole components. | If it collected the leads also that would be helpful. | I am thinking of plexiglass or something that the board | could be plac
Electronics Forum | Mon Jan 04 16:55:47 EST 2010 | dyoungquist
We use a HEPCO model 3000-2 (hepcoblue.com) to shorten leads on various through hole components before we solder them on a pcb. You will have to verify they have a die that works with your particular LED module. If they do, this is what I would rec
Electronics Forum | Fri Nov 08 14:53:11 EST 2002 | davef
Cut the sucka off the board and move on.
Electronics Forum | Thu Jan 26 08:54:31 EST 2006 | Chunks
Depends on what you're kind of thru-hole you're placing. Cutting, forming and placing TO-220s are a lot different than VCD components. Can't just slap any ol' name out der!
Electronics Forum | Thu Nov 14 18:06:05 EST 2019 | tey422
It doesn't really matter which PnP machine you use. The correct way to cut down the variety is to use the same mfg p/n part for the whole time. Some would try to cheap by increasing the part size tolerance, but that's not the right way to do it. To
Electronics Forum | Wed Apr 01 11:24:24 EST 1998 | niall hayes
Hello, We are currently trying to design and ultimately implement a system that will be able to count and manage component placement for three Sanyo chipshooters on three SMT lines. As the number of components decreases in the reels we want to be ab
Electronics Forum | Wed Feb 01 10:53:56 EST 2006 | edruppert
AMS, Are you aware that you will have to purchase several types of insertion equipment for different part types? You will need an axial inserter, radaial and DIP inserter to cover the gamut of thru-hole insertion. Even then you may not cover oddba
Electronics Forum | Mon Oct 18 14:31:01 EDT 2021 | charliedci
We recently purchased a Scienscope AXC-800 III which can count 4 7" reels at one time in seconds. It can count tubes, trays and bulk as long as keep the components down to 1 layer (which for bulk is not ideal). so far we are very happy with, cuts dai
.gif)
.gif)
