Electronics Forum | Mon Dec 12 18:03:15 EST 2005 | Diane
Yes to be quite frank and stright foward your trash cans and bags do affect ESD. Esd also tends to jump thereore you do not actually have to touch the parts to create electrial overstress to the parts. As was mentioned in a previous posting there a
Electronics Forum | Fri Oct 23 16:16:01 EDT 1998 | Bill Herman
| I am looking for some esd storage containers for tape and reel components in the stockroom. Shelves or bins. Any ideas. | Try contacting Aerofeed Inc. Phone 215-257-1151. Fax to 215-257-1533. They have ESD controlling cabinets for tape and reel c
Electronics Forum | Fri Oct 23 06:05:21 EDT 1998 | Pat Copeland
I am looking for some esd storage containers for tape and reel components in the stockroom. Shelves or bins. Any ideas.
Electronics Forum | Wed Oct 28 20:40:11 EST 1998 | Marla
| I am looking for some esd storage containers for tape and reel components in the stockroom. Shelves or bins. Any ideas. | We use the Brick Container conductive heavy duty cardboard reel holders. They are very durable and cost effective.
Electronics Forum | Tue Dec 14 02:19:03 EST 2010 | sachu_70
With lower Humidity levels, we expose to greater risk towards ESD related failures seen on components. Pl. ensure to have your entire work area fully guarded against ESD and maintain proper material handling instructions across the entire flowline un
Electronics Forum | Thu Dec 12 21:38:02 EST 2019 | peterhuang
Does anyone encounter components sticky problems? I think it should be ESD problem in cover tape.
Electronics Forum | Mon Mar 28 09:56:36 EST 2005 | n wolford
We have a granite table out on our production floor. We use the table along with metal parallel bars and a height gauge to measure component height. Some of these boards have components on them that may be ESD sensitive. Does anyone have experience w
Electronics Forum | Thu Jan 05 23:49:12 EST 2017 | anhsang38
Dear All I'm having proplem with a component(resister). it was over turned after feeding,Depending the reel component so the mounter will be error when picking. i have already check feeder, it is ok. I'm suspecting the reel component was been esd.
Electronics Forum | Tue Nov 29 17:18:26 EST 2022 | davef
Yes, electronics manufacturing is a volume producer of cardboard waste. If the components are ESD-critical, cardboard and most plastics are not ESD safe. Static charges can be generated on these materials during handling by the friction of dissimila
Electronics Forum | Fri Nov 07 18:12:50 EST 2014 | cot628
This issue is coming from a customer. The customer demands that we do not mechanically center or test passive components, because of issues they had in the past. There has been a studies that it takes about 8-10 newtons to damage chip. Most of our pa
.png)
