Electronics Forum | Thu Oct 28 13:36:14 EDT 1999 | Bart Smith
I am a design engineer and have a circuit board design with a 292 pin BGA on it. The board manufacturer is experiencing a failure rate of about 2.8% on the BGA device due to soldering problems. This is my first experience with BGA. How does the 2.
Electronics Forum | Mon Sep 16 09:47:33 EDT 2013 | dilogic
I would appreciate if you can share your experience with pick failure rates, preferably for 0402 parts. Also, what percentage do you consider acceptable?
Electronics Forum | Wed Sep 18 15:41:59 EDT 2013 | cbeneat
For 0402's, if the operator is paying attention, our equipment Panasonic CM 402/602/NPM's run at about .001%. Again this is dependent on an operator that pays attention to the fail rate. We usually don't have too many problems with 0402's, LED's ar
Electronics Forum | Mon Sep 16 13:57:31 EDT 2013 | emeto
By tape manufacturer you can have up to two empty slots in the tape. That means you should have two retries after the first pick up.
Electronics Forum | Tue Sep 17 17:55:36 EDT 2013 | dilogic
Yes, I know all that, but I am interested in some real figures from the field. That is, what percentage of mispicks do you experience on average (for large runs, of course)?
Electronics Forum | Mon Sep 16 13:29:37 EDT 2013 | larrygroves
a lot depends on the age and type of equipment you are using . Older equipment can have a lot of problems with smaller parts. If all is well with your feeders and machine you should expect something like 99.8 to 99.9 percent. some parts will be ident
Electronics Forum | Fri Oct 29 05:23:00 EDT 1999 | Wolfgang Busko
Hi Bart, that�s much to high. If that would happen to me my boss would tear my head off. For improving the yields you must find the cause for the soldering problems. What are the symptoms? What could be the cause for the symptoms? Could be design pr
Electronics Forum | Mon Mar 21 02:41:29 EDT 2011 | kemasta
Hi It's me again. Our products need to pass a chamber test 45c/36hrs after the PCBA completed batch of functional tests and assemble in to case. We found 1 unit was functioning for 24hours in the chamber, but hang after that. We tried to re-boot the
Electronics Forum | Tue Dec 18 15:05:58 EST 2001 | blnorman
What is the maximum allowable thermal ramp rate for wave solder. We have a "short" machine used for selective soldering. To get the boards up to temp, we need to exceed our normal 2�C/sec. Are there any IPC documents governing this process? Anyon
Electronics Forum | Thu Feb 10 09:09:30 EST 2005 | russ
99% (there will always be that one that gets jacked somehow). Your old placement equipmment may affect this by dropped parts that get underneath the BGA, etc.. hopefully the placement accuracy will at least get the parts halfway on pad and they will
