Electronics Forum | Thu May 22 13:31:52 EDT 2003 | Dave
If you have a component with a height issue and want to lay is down (capacitor in this case), what are the best methods to consider? RTV, epoxy or something else?
Electronics Forum | Tue Apr 05 12:45:01 EDT 2005 | cyber_wolf
Make sure your matrix tray is up high enough. The components in the matrix tray should be at least at board level. Also check your component height in the package list. If all that is OK then, check those Z locks I spoke of earlier.
Electronics Forum | Thu Apr 14 12:33:30 EDT 2005 | russ
Have you checked the component height in the package data to ensure that it is the same? how about the PCB itself, could there be some warp or twist thay may cause the component to be dropped onto the board? any support problems? this is all I can
Electronics Forum | Fri Jul 21 12:01:09 EDT 2006 | CKH
Hi Folk, what is the possible cause for the components (e.g ICs) to be Solder shorted? I know that one of the cause is the solder paste height is too thicked. Could anyone advise me on then possible root cause and solution(to minimize the rate of so
Electronics Forum | Thu Apr 24 10:33:00 EDT 2008 | pjc
There is a field retrofit to increase the 25mm (0.98425") standard clearance up to 45mm (1.77165"), its not quite the 2", but close. You will have to recreate your component library though. For more details, contact Mirtec tech support at http://www.
Electronics Forum | Tue Apr 29 20:26:03 EDT 2008 | sys_steven
You can adjust to 45mm clearance, But I would recommend staying at 25mm if working with fine pitch and smaller passive components.
Electronics Forum | Tue Jan 05 10:28:48 EST 2016 | paperbackryder
there is (or was), a CCD camera option to enable component heights up to 11mm part over part.
Electronics Forum | Fri May 08 17:55:37 EDT 2020 | cyber_wolf
The squish is determined by the spring in the nozzle. If Z0 or table level is out, you would see it on more than one component..most likely Make sure board thickness and component height are correct. Also make sure you have board support installe
Electronics Forum | Thu Aug 26 11:01:47 EDT 1999 | Wolfgang Busko
| For space contracts we have to mount chip capacitors/ resistors etc 0.1 to 0.4 mm from the pad height. | | This is to compenstae for the CTE differential in the substrate/component and also to ensure cleanliness. | | Does anyone have any new idea
Electronics Forum | Wed Sep 01 14:07:41 EDT 1999 | Dave F
| For space contracts we have to mount chip capacitors/ resistors etc 0.1 to 0.4 mm from the pad height. | | This is to compenstae for the CTE differential in the substrate/component and also to ensure cleanliness. | | Does anyone have any new idea
.png)