Electronics Forum | Wed Apr 04 09:20:20 EDT 2012 | acsscott
I have continued to try and make this work, but I've had no success. I have tried everything that everyone has suggested. It might be the component height, but I can't change that. I guess I could increase the resistor thinkness, and add some heig
Electronics Forum | Mon Dec 14 02:56:26 EST 2015 | s_marius
Good Day for Everyone! TOPAZ XII can handle 6.5mm height components easily. Is it possible to mount 10mm? The problem is that the picked high component pushes away other placed high component. Camera alignment works well. Please share your experien
Electronics Forum | Thu Apr 24 11:44:30 EDT 2008 | mikesewell
I was needing to go over 1.77" for a few assemblies.
Electronics Forum | Mon Jan 02 09:39:34 EST 2017 | dyoungquist
I do not know the limit for component height on Hydra.
Electronics Forum | Sat Jun 27 10:45:18 EDT 2020 | SMTA-Davandran
Hi Indhu, Check for solder paste height. Please manually add solder, mount component and reflow.
Electronics Forum | Mon Mar 28 09:56:36 EST 2005 | n wolford
We have a granite table out on our production floor. We use the table along with metal parallel bars and a height gauge to measure component height. Some of these boards have components on them that may be ESD sensitive. Does anyone have experience w
Electronics Forum | Wed Jul 20 16:08:34 EDT 2005 | grantp
Hi, I think the comment about the board height is because the MYDATA checks the board height each time it loads a tool so this is eliminated from being an issue because the machine knows the PCB height. I don't think it's so much what height the PCB
Electronics Forum | Sun May 17 13:46:30 EDT 1998 | Steve Gregory
Hi All! I've been reading this conversation which prompted me to break out the IPC-SM-786A from the IPC manuals from our parent company in Maryland sent us (we're just starting up in California). It's the Procedures for Characterizing and Handling of
Electronics Forum | Wed Sep 22 09:25:42 EDT 1999 | Wolfgang Busko
| | i'm sure everyone has run into this at one point or another. I have a thin pcb .025 that is single up that has to be built on a pallet. does anyone have any tricks to the pallet design that will help to hold these boards down during the scree
Electronics Forum | Wed Feb 23 21:24:42 EST 2000 | Dave F
Chris: Whatever way you decide to define your pads, use the same type on the component and the board. Non-solder mask defined pad advantages: � No point-of-stress concentration at edge mask and solder ball � No CTE mismatch at edge mask and solder
.png)