Electronics Forum | Fri Mar 31 16:57:51 EST 2006 | stepheniii
97% to 99%? I've heard of one company that managed that but only after a big six sigma project. And they had minimal stock anyways. I think if everyone picked 100 components to cycle count, that the average accuracy would be around 80% . That is
Electronics Forum | Thu May 09 14:27:19 EDT 2024 | spoiltforchoice
I have tried cover tape extenders from a multitude of sources and they all seem to be made of the same plastic. I think your best solution might be to splice on carrier tape extenders instead, these can come with conventional cover tape already fitte
Electronics Forum | Wed Dec 13 12:08:57 EST 2000 | Stefan Witte
Apparently the adhesive tape peels off from the joint, which could have some reasons. 1. There should be an overlap of the cover tape, as Cal mentioned. The new cover tape laying over the old by approx. 2mm. I also peel the cover tape a bit off, whi
Electronics Forum | Thu May 04 12:02:37 EDT 2017 | tombstonesmt
Splice in carrier tape left over or purchase leaders from suppliers like Sierra. http://tapesplice.com/product-category/flat-punched-carrier-tape/
Electronics Forum | Wed Feb 15 16:10:13 EST 2006 | slthomas
My understanding is that you get a reading that's the average of all of the jumped points if you jump tc wires with conductive tape. If you're doing multiple parts on a board with varying masses and don't control the attachment method (i.e., how mu
Electronics Forum | Fri Jan 15 09:55:58 EST 2016 | dyoungquist
Mycronic (Mydata) makes a solution for this. Product name is Tape Seal 8 or Tape Seal 1216 Tape Seal 8 - Part No: L-014-1600 Tape Seal 1216 - Part No: L-014-1572 I have used them and they work well.
Electronics Forum | Thu Jan 14 15:44:20 EST 2016 | sssvajunas
Hello, after we finish project (mydata) we unload tape from feeder and place a stick on the edge of tape. Maybe somebody can help with alternatives to this? (plastic clips) becouse then unloaded tape is used for another project it is sticky
Electronics Forum | Thu Mar 05 17:49:57 EST 2009 | snsmt
i have been looking for masking tape as well. I just came across esdtapes.com and got a sample of one of there tapes "CM300." I tested a component by taping it completely off and submerging it in water, just to see if it will soak through. The resu
Electronics Forum | Wed Feb 15 08:02:04 EST 2006 | davef
Se�or Tech Search the fine SMTnet Archives. For instance: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=25210 Roger Saunders, President, Saunders Technology summarized the pros and cons of taping thermocouples as [He's taking about Ka
Electronics Forum | Wed Aug 22 07:24:34 EDT 2012 | ericrr
how about this for resistor & capactors with 4mm pitch, all measurements in millimeters. cell A1 "Input inside diameter" answer in cell B1 cell A2 "Input outside diameter"answer in cell B2 cell A3 "Input layer width,(from inner to outside layer) (no