Electronics Forum | Mon Sep 26 18:53:30 EDT 2016 | chabscan
Could it be possible in my Quad 4c, to increase component size tolerance to reduce the rejection of components? Could this have an impact in the event of the machine picking a component off center? As in if the machine picks a compnent off center but
Electronics Forum | Tue Sep 27 11:43:32 EDT 2016 | tnisbet
Yes you can open the tolerance, and that’ll usually work for a bit. Is the LAE is linked to multiple parts? If so, then the easiest thing is to open the tolerance. If not, that’ll require another route to try. Is it happening to all of the components
Electronics Forum | Mon Mar 29 15:15:17 EST 1999 | twinston
Does anyone know of a contract manufacturing house that can guarantee smt component placement and can verify placement of +/-.015? Thanks in advance
Electronics Forum | Mon Mar 29 15:16:30 EST 1999 | twinston
| Does anyone know of a contract manufacturing house that can guarantee smt component placement and can verify placement of +/-.0015? | | Thanks in advance |
Electronics Forum | Mon Mar 29 15:39:47 EST 1999 | Stefan Witte
| Does anyone know of a contract manufacturing house that can guarantee smt component placement and can verify placement of +/-.015? | | Thanks in advance | There may be several contract manufacturing houses with .015 capability and automatic opt
Electronics Forum | Thu Apr 12 16:55:58 EDT 2018 | esoderberg
I require component engineering to spec in multi vendor parts as long as the following exists 1.Mechanical +/- 15% 2. Same orientation in pocket 3. Same pocket dimensions I have to beat the engineering a few times per year but I think they have the
Electronics Forum | Tue Mar 30 22:43:36 EST 1999 | dean
| Does anyone know of a contract manufacturing house that can guarantee smt component placement and can verify placement of +/-.015? | | Thanks in advance | Question: mm, inches, or mils? I can do it. However, what is your reliability level? 9
Electronics Forum | Thu Nov 14 13:32:45 EST 2019 | vabben
Hello, I recently started working as a process engineer focusing on ASM Siplace. I'm just curious about component shape dimensions. For instance, we have a standard component shape for 0402-component. The problem is we have so many second source and
Electronics Forum | Fri Jan 19 13:31:14 EST 2007 | lit51
Is the failure just out of tolerance or is it non functioning? For tolerance problem, compare the x-rays of the good and bad units. It will take a very high resolution x-ray to spot the differences. Changes in capacitance values can occur based on
Electronics Forum | Fri Sep 24 11:08:13 EDT 2004 | davef
We're not sure what you mean by temperature sensitive components. From an assembly process stand-point, every component we use is temperature sensitive to one level or another. More specifically, some of our products use polyphenylene sulfide (PPS)
