Electronics Forum | Tue Dec 06 16:20:48 EST 2005 | jsloot
Does anyone have a list of SMT components with their weights? For instance, a PLCC64 pin = X grams. I am not even sure if such information is really valid but it would be interesting to know when developing a reflow profile for convection ovens on a
Electronics Forum | Sun Dec 02 22:00:21 EST 2007 | shy
The idea for solder at bottom side is for component such as SOIC, QFP and chip. This solder is needed since not entire bottom component had glue. that's why we're combining both solder paste and glue and reflow at the same time.
Electronics Forum | Fri Nov 30 08:35:51 EST 2007 | stepheniii
We put glue on the bottom of the board that already has the topside SMT mounted. We populate the board. We put it through a cure profile. At this stage the topside components are soldered on. The bottom side components are glued on with NO solder on
Electronics Forum | Thu Nov 29 13:05:46 EST 2007 | stepheniii
I really hate to ask but must. Are the components that are falling off, the components that don't have glue? Seriously not all the parts on the bottom are glued on? How do they stay on during the wave? The normal way is to run the top SMT as normal
Electronics Forum | Fri Nov 23 07:51:25 EST 2007 | shy
Hi there, kindly help to advice me either epoxy/glue at bottom SMT component such as chip package 2012 will cause the component to be non-wetting after run reflow process?
Electronics Forum | Mon Dec 03 02:23:12 EST 2007 | lococost
yigh, loose the glue, put paste on ALL bottom SMD components and cover ALL SMD components with peel off before wave.
Electronics Forum | Tue Nov 27 07:36:29 EST 2007 | shy
solder the part is for SMT component (located at top side and bottom side) and wave solder is for THP (located at top side only).
Electronics Forum | Mon Nov 26 10:36:19 EST 2007 | davef
Sure, if you slopper or schmush chipbonder onto pads, solder will not take on that portion of the pad, regardless of the component.
Electronics Forum | Mon Nov 26 20:11:41 EST 2007 | shy
Yes, i'm agree with you davef but i'm not put the chipbonders onto pads. i'm put the chipbonders at the beneath component (center between both component terminals) which the idea is to hold the component during wave soldering which might cause the co
Electronics Forum | Tue Nov 27 06:11:42 EST 2007 | shy
Hi Loco, my PCBA got top side and bottom side and 90% SMT and 10% THP (top side) which need to be cover by wave solder. And that's why i need to go through reflow and wave.
