Electronics Forum | Wed Jul 12 06:29:11 EDT 2017 | jamesbarnhart
Soldering electronic components like electrolytic capacitors can be some of the most difficult terms in PCB repair. Electrolytic capacitors, like other components, come in two main formats. 1. Through-hole capacitors have long leads designed to pass
Electronics Forum | Wed Jul 12 07:21:37 EDT 2017 | cyber_wolf
Aaaand how does this help ? This was a soldering question. He knows it's difficult, he's asking for soldering advice not a definition of what the components are.
Electronics Forum | Wed Jun 19 08:51:49 EDT 2002 | davef
Try this: * Remove PTH components that cannot resist baking like, plastic sockets & electrolytic capacitors. [NOTE: It may be econonomic to sacrifice some of the PTH components that cannot resist baking.] * Bake the board. * Remove, reball, and repla
Electronics Forum | Fri Apr 04 13:03:00 EDT 2014 | jyo_409
What is the inspection procedure How to test leakage current Is 100% checking is required at IGI inspection What is the shelf life of the capacitor How much period shelf life is recommended for these capacitors How to check the ripple current of thes
Electronics Forum | Thu Sep 03 11:18:04 EDT 2009 | dyoungquist
We do not have any electrolytic capacitors on this board.
Electronics Forum | Thu Feb 17 14:42:52 EST 2005 | gregp
I would first check the alignment of the flux capacitor to the roto pluker mechanism.
Electronics Forum | Mon Feb 21 09:55:52 EST 2005 | Dougs
i think O.Tarango is still looking for the flux capacitors
Electronics Forum | Tue Nov 14 01:28:10 EST 2006 | CHITRA
When we reflow solder SMT PCB with SMT Electrolytic capacitor- 5MM sized ,the capacitor gets burst and all other adjacent and surrounding components also get disturbed. What could be reason for this. What should be done to avoid this problem.
Electronics Forum | Fri Jan 12 14:05:33 EST 2024 | rygenetic
Hi @calebcSMT, It is generally recommended to avoid coating the entire body of aluminum electrolytic capacitors. These capacitors rely on the venting of gas in case of failure or overvoltage conditions, and coating the entire component could hinder
Electronics Forum | Mon Feb 21 13:21:57 EST 2005 | O.Tarango
Firstable, thanks for all your comments,sorry if my question was too un detailed, I really need your help on this, actually we are using a 4796 HSP in our SMT process most of the incidences of mis aligned component are on two 0420's capacitors Rega
