Electronics Forum | Thu Dec 23 22:31:47 EST 1999 | Vincent Chen
Hi!Charlie, 1.Are you retrofitting your spray fluxer in your wave soldering machine? If you are, please ensure that you have a air knife just before the preheater!Fluxe fumes tends to accumulate and that could be dangerous if your air exhaust is not
Electronics Forum | Mon Dec 20 12:42:15 EST 1999 | Charlie
There is a need to set up the spray fluxer on our wave machine. I'm looking for guidelines and comments form others who have done this set up. Also, is there any rule of thumb at visual inspection when there is too much or not enough flux being appli
Electronics Forum | Fri Sep 25 10:28:08 EDT 2009 | leemeyer
Are you running Q-soft software or is this an older machine running central controller ? Do you have seperate profiles set up for 0603 caps and 0603 resistors or just one profile for all 0603 parts. It sounds to me that you might be scanning to low a
Electronics Forum | Mon Sep 28 06:03:28 EDT 2009 | bobpan
You are probably scanning below the part. Adjust the scan height closer to 0 ex..(.005) and see if that works. If not....its probably the z-rod and the nozzle not seating on it correctly. Good luck
Electronics Forum | Thu Sep 24 17:00:03 EDT 2009 | dogsbody
would any body be able to supply me with infomation on how to adjust a quadalign unit,as a unit on my line will not pick up 0603 resistors,but will pick up thicker 0603 caps. My manuals offer no help.I have run the aligner calibration with the cone t
Electronics Forum | Fri Sep 25 14:58:33 EDT 2009 | gantry228
It is apparently a Q-series machine, if the adjustment for pitch and roll doesn't work. You may have to loosen or remove the quadalign then check the "wavey" washers to ensure they are there and opposing each other (these provide like a spring effect
Electronics Forum | Tue Apr 09 21:57:42 EDT 2019 | alexvolovich
If you were able to do a first/last part, then your tray wagon is set-up. You need to go to Tray Types and program the tray that will match the piece of tape you have. Then you should be able to add your component to the tray wagon.
Electronics Forum | Mon Dec 20 17:02:39 EST 1999 | Dave F
Charlie: There's a lot of background setting-up fluxers (including sprayers) in the archives. Chris Shea wrote a paper that's in the library (or where ever SMTnet stores stuff like that) that is pretty good. Good luck. Dave F
Electronics Forum | Sun May 01 19:47:23 EDT 2016 | jasltd
Hi there, we have recently bought 2 2nd hand DEK printers & both are coming with chillers. Does any one have any info on setting them up & what they have used to fill them? Don't think they are coming with Manuals so any hints on getting one of thos
Electronics Forum | Mon May 02 10:13:42 EDT 2016 | swag
If it's like ours, it's an AC unit, not a chiller. Easy to hook up with a hose to the printer + power to the unit. You'll need to empty the water from the drip pan from time to time (collects condensation).