Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Mon Sep 28 10:12:53 EDT 1998 | Chrys
| Hello, | I need some users information about "Air knif" in wave soldering: | 1. Does it decreases bridging ? | 2. Is it self installed of a purchesed kit (if purchesed, who are the recomended vendors) ? | 3. Any other information about the issue. |
Electronics Forum | Thu May 28 09:23:59 EDT 1998 | Chrys
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |
Electronics Forum | Fri Jul 13 05:25:03 EDT 2001 | surachai
I would like to know about the efficiency of hot air knife debridging option with wave solder machine ,anyone use this option please suggestion to me about yield ,side effect or profitable of this option . Thanks.
Electronics Forum | Thu Aug 31 11:34:44 EDT 2006 | flipit
Could you get by using a Wenesco or Air Vac PCBRM10 wave pot instead of an entire wave soldering machine?
Electronics Forum | Wed Jul 29 07:06:44 EDT 2009 | patrickbruneel
Deni, This looks more like webbing and not flux residue. Webbing is caused by not enough flux to protect the surface resulting in oxide webs sticking to the board surface. The insufficient flux can be caused by: - Weak flux foam head - Air knife p
Electronics Forum | Mon May 07 11:09:49 EDT 2007 | davef
4 Fluxer Operation 4.1 Set-Up and Check-Out the Fluxer 4.1.1 Spray Fluxer Set-Up and Check-Out 4.1.1.1 Pass a sample unsoldered board through the machine. 4.1.1.2 Remove the board just after passing through the fluxer and the air knife. 4.1.1.3
Electronics Forum | Thu Aug 21 14:23:56 EDT 2003 | kenBliss
In order to service your wave solder machine safely, the following needs to be understood. Ladling dross out of the machine and putting it in into a coffee can or similar is not safe and puts operators and other employees at risk. Protecting the se
Electronics Forum | Tue Mar 07 17:00:39 EST 2023 | proceng1
Prior to the Generators, we bought tanks of N2. As long as you have an air compressor that can supply the generator, it's pretty much maintenance free. You change filters every year. In almost 15 years, other than changing filters, we've had to r
Electronics Forum | Tue Mar 07 21:28:30 EST 2023 | stephendo
What purity? To get 99.999% pure you will need dewers of liquid nitrogen or a two stage system. (and a dewer will last about a month and a half even if you don't use it as it outgasses.) But you can get reasonable purity with a wall mounted single s
winsouce.jpg)
