Electronics Forum | Thu May 13 20:38:32 EDT 1999 | lima
Does anyone know of any industry guidelines for the exhausting of volatiles in reflow ovens? I've seen some numbers like 1,000ppm for the oven atmosphere, but is this typical? My concern is the volatiles in my WS629 solder paste may be attacking th
Electronics Forum | Fri May 14 00:16:28 EDT 1999 | Mike D.
| Does anyone know of any industry guidelines for the exhausting of volatiles in reflow ovens? I've seen some numbers like 1,000ppm for the oven atmosphere, but is this typical? | | My concern is the volatiles in my WS629 solder paste may be attack
Electronics Forum | Fri May 14 15:03:19 EDT 1999 | lima
| | Does anyone know of any industry guidelines for the exhausting of volatiles in reflow ovens? I've seen some numbers like 1,000ppm for the oven atmosphere, but is this typical? | | | | My concern is the volatiles in my WS629 solder paste may be
Electronics Forum | Wed Jan 10 14:15:48 EST 2001 | Claude_Couture
We have an old Conceptronic oven (Discovery Mark IV) which we use in the glue process. The video monitor just died. This is a 11 year old oven with a Goldstar model 1420 PLUS monitor. There are no specs in the manual and Conceptronic is not much help
Electronics Forum | Thu Jul 30 11:00:19 EDT 1998 | Matt Harding
I have some potential unused SMT equipment which may be candidates for sale. Any input regarding the value or expected going rate would be appreciated. CONDITION: E - Excellent Condition F - Fair Condition G - Good Condition Equipment List: BRAND
Electronics Forum | Mon Aug 03 22:00:50 EDT 1998 | Dave F
| I have some potential unused SMT equipment which may be candidates for sale. Any input regarding the value or expected going rate would be appreciated. | CONDITION: | E - Excellent Condition | F - Fair Condition | G - Good Condition | Equipment Li
Electronics Forum | Thu Apr 23 12:22:35 EDT 2015 | ercdave1
Thank you for looking at my post. my problem is this. I have a Conceptronic Mark 111 Reflow oven that randomly turns off zone 4 and stops the conveyor belt. turning the heater and the conveyor off on the software and restarting them gets things ba
Electronics Forum | Sat Apr 25 11:37:56 EDT 2015 | ercdave1
DucHoang, thank you for your reply. as you mentioned I checked the solid state relays on the input and output side. I did get power coming out of all even when the conveyor was stopped. I will mark them with their position and swap some to see what h
Electronics Forum | Sat Jan 05 00:13:16 EST 2002 | Chris Veeneman
I have experienced the same problem with my Mark 3. I found the problem to be the solid state relays in the electrical control panel. Towards the front of the machine below the breaker rails. My oven's computer screen would show all was fine but my
| 1 |
