Electronics Forum | Wed Jan 15 00:52:40 EST 2003 | jamstart
What about the latest Conceptronic Freedom SE? Anybody here care to comment?
Electronics Forum | Fri Jan 16 01:51:44 EST 2015 | hemant_pang23
Pls help for getting the spare part no TOP & Bottom heaters for the Conceptronics BGA Rework Freedom 3000
Electronics Forum | Tue Aug 01 00:34:45 EDT 2000 | Antonio
I have evaluated SRT, Air-Vac and Conceptronic rework stations. All three machines offer great BGA and Micro BGA rework capability. But the one I have preferred is the Conceptronic Freedom 2000, as a matter of fact I have purchased two freedom 2000 i
Electronics Forum | Fri Nov 22 13:12:07 EST 2002 | bcceng
Maxtim, the rework stations you mentioned are the lower end low cost units, all great machines. Now days you can get a real deal in the used market on the top of the line models offered in rework stations. There are three rework station that I consid
Electronics Forum | Tue Apr 27 14:55:37 EDT 1999 | Tony
| Has anyone used the APE SNIPER rework station for BGA packages? | I have not used it, but I have used the SRT and Conceptronics Freedom 2000 rework stations. Both are really good BGA rework stations.. Thanks
Electronics Forum | Mon Nov 25 20:24:13 EST 2002 | bcceng
Maxtim, Again I have implemented BGA rework in four CM's and the machine that I have selected is the Conceptronics. In contract manufacturing you will have to be prepare to rework from the smallest to the largest boards with lots of ground planes. Co
Electronics Forum | Wed Jan 26 12:36:22 EST 2000 | Franck Bourrieres
Where did you find a BGA 2000???? This machine is not saled anymore. The new one is the 3592 and include a large underboard heater which shouldn't be "under-powered" but this depend of the kind of board you are repairing. If you really want a large u
Electronics Forum | Mon Nov 25 16:46:17 EST 2002 | timreisenleiter
Any experience with the Conceptronic freedom-2000/HGR2000 system? I have the opportunity to pick one up for about 15k USD. The system new is approximately 51K, putting it into the high end of BGA/CSP/chip-scale rework systems, the specs. are really h
Electronics Forum | Wed Nov 01 07:41:39 EST 2006 | billyd
I'm reworking lead free BGAs now, on a Conceptronics Freedom 3000. I use flux only (no-clean, Indium) all the time, with no issues. If you go to paste, you also understand that you still have to hit the same temperatures as with flux, as the solder i
Electronics Forum | Wed Aug 18 16:26:21 EDT 1999 | Tony
Yesterday as I was creating a profile on a plastic BGA using Conceptronics freedom 2000 rework station, I happend to discover that I was able to remove solder bridging from a plastic BGA. This is what I did. Created a removal profile, I had a board
