Electronics Forum | Thu Aug 25 06:57:41 EDT 2011 | SBecmpe
I just started with this company and the machine is being used for a different process. I am noticing small differences in the wiring that do not appear to be original. Ex. The SMEMA is missing. There are unmarked wires. Schematics would really set m
Electronics Forum | Mon Jan 07 10:56:40 EST 2002 | bcaler
Who did you buy this oven from? What is the model number? I bought a used Conceptronic oven last year...It ran great when I saw the demo. But, when is arrived at our factory we found someone pulled out some relays and it wouldn't heat. Hope you h
Electronics Forum | Thu Mar 07 04:09:45 EST 2019 | rhoderik
Thanks so much. I need also the wiring schematics, and the manual for the commands if they are available. Thanks again.
Electronics Forum | Sat Aug 22 16:53:32 EDT 2020 | jmelson
I'm trying to diagnose a Quad QSA-30A machine that won't go ready. I have the machine technical drawings, they have overall machine schematics and cable wiring on most of the cables, but that's all. Does anyone have access to the schematics of the
Electronics Forum | Thu Apr 23 12:22:35 EDT 2015 | ercdave1
Thank you for looking at my post. my problem is this. I have a Conceptronic Mark 111 Reflow oven that randomly turns off zone 4 and stops the conveyor belt. turning the heater and the conveyor off on the software and restarting them gets things ba
Electronics Forum | Tue Jun 15 16:09:02 EDT 2004 | dougt
Our "mechanical engineering dominated" company is allowing the electrical group to purchase some software to produce machine wiring diagrams. The only stipulation is that it has to be low cost. Can anyone throw out any products? I'm not looking fo
Electronics Forum | Thu May 30 20:09:58 EDT 2002 | myu
Thank you very much, Dave and Steve. I got paste and wire from Indium and Qualitek. Are there anybody with high-temperature reflow experience (330 degree C)? Is it OK to use Regular Convection Reflow Oven (We have a Conceptronic HVC 70, 5 zones) ?
Electronics Forum | Sat Jul 19 12:22:55 EDT 2008 | operator
Are there any softwares OR functions inside of the softwares that allow a designer that is creating a very large complicated wiring diagram with say....many terminal blocks and connectors etc... to run a point to point check on his drawing? Bascially
Electronics Forum | Mon Nov 30 09:33:51 EST 2020 | chucherry5076
This articles shows how to read circuit diagrams for beginners in electronics. Learn to read electrical and electronic circuit diagrams or schematics. A drawing of an electrical or electronic circuit is known as a circuit diagram, but can also be cal
Electronics Forum | Sat May 07 15:49:19 EDT 2005 | marcelll
Need a wiring info from somebody who have the schematics for a GSM running the old vision system AIM 3500. There's 2 cables plugging in the vision box, "vision DigA" & "vision DigB" with DB15 connector. I need the pin out of these 2 cables to con
winsouce.jpg)