Electronics Forum | Tue Feb 07 10:25:37 EST 2017 | ttheis
Thanks for the tip. I'm still getting familiar with the machine by reading the manuals as I have time. Was wondering what type of solvent you use to clean the dispensing mechanism parts? Or do you not clean anything and simply dispose of the syring p
Electronics Forum | Tue Jan 13 16:40:03 EST 2004 | Jacob Lacourse
Hi folks, I have a conformal coating application where I need the coating to be UV stable for a number of years without any crazing or cracking of the coating. I have looked for such a coating and have come up empty handed. Much of the circuit boar
Electronics Forum | Fri Feb 03 17:14:49 EST 2017 | westshoredesign
You should have no problem. We use a very dated Asymtek machine (Automove 303) retrofitted for dispensing, air over syringe. It took time and some tinkering with. But all things considered, we're able to achieve remarkable results. I would recommend
Electronics Forum | Tue Mar 06 17:14:40 EST 2001 | bschwyn
Is conformal coating necessary for products that are used indoors?
Electronics Forum | Wed Feb 23 10:01:00 EST 2005 | frankracine
Dave, Few questions concerning your Umiseal 1B73. To cure your Acrylic coating do you respect specification ( 2Hrs-170degree F) or you go faster than that? What do you use to cure it? Do you have to clean your nozzles each day or each monday beca
Electronics Forum | Mon Mar 21 09:23:34 EST 2005 | sforman1
Some UV cure coatings do not have the correct rheology for sticking to small sharp corners. 984 is one of them. MicroCoat Technologies, Allen, TX makes one that works every time.
Electronics Forum | Wed Mar 30 14:51:19 EST 2005 | Cmiller
We are looking at switching to UV cure for faster throughput. Does anyone know of any cost effective coating manufacturers? The pricing we are getting back are around $250.00 a gallon in 5 gal pails. This is more than twice what we pay for our curren
Electronics Forum | Mon Feb 06 17:24:26 EST 2017 | westshoredesign
So I had the same question too when I was setting ours up. My lazy (and cheap) solution was: for each program I have a universal path that is used up to the first dispense instruction and after the last one then I covered the surfaces underneath tha
Electronics Forum | Sun Apr 10 03:25:35 EDT 2005 | Peter
Normally, some conformal coatings do not have very good wetting properties, that should be basic function of a good coating material (the same reqirement as avoid bubbles during coating process)! For UV curing conformal coatings, you can try Lackwe
Electronics Forum | Fri Oct 29 09:08:21 EDT 2004 | davef
Electrochemical migration under conformal coating: That's possible. Very few conformal coatings are water resistant. So, if you have ionic material on your board, standback. Uncured material under several IC: Materials like yours need moisture fro
