Electronics Forum | Wed Jul 06 20:15:51 EDT 2005 | Gary Bremer
The good old days weren't all that bad. When I needed to have a specification callout for a conformal coating on an engineering drawing, I just used MIL-I-46058, type UR (for example), and the drawing checkers were quite happy. Since MIL-I-46058 ha
Electronics Forum | Thu Mar 08 01:19:16 EST 2001 | Mike Moninger
The environment essentially defines the need for coating. "Inside" may mean inside a men's locker room with attendant high humidity or inside a climate-controlled clean environment. Conformal coatings offer protection against moisture, fungus, chemi
Electronics Forum | Thu Sep 10 17:13:31 EDT 2015 | tombstonesmt
There are factors that manufacturers have taken into consideration when dealing with coating. On/off times, dispense speeds, heights, etc.. Dedicated software with tools to easily map out paths are a godsend. We made our own coating machine with a s
Electronics Forum | Sun Apr 10 03:25:35 EDT 2005 | Peter
Normally, some conformal coatings do not have very good wetting properties, that should be basic function of a good coating material (the same reqirement as avoid bubbles during coating process)! For UV curing conformal coatings, you can try Lackwe
Electronics Forum | Thu Feb 17 15:01:23 EST 2005 | davef
We're not familiar with your DYMAX #984-LVUF. The problem is not with your conformal coating. The problem is with your 0805 [and not all of 0805, probably just those from a specific supplier]. This lack of coverage of components is called dewetting
Electronics Forum | Thu Mar 31 10:14:06 EST 2005 | davef
There's some nice low-VOC uV coatings out there. We don�t use uV cured coatings, but try: * http://www.emersoncuming.com * http://www.dymax.com * http://www.mgchemicals.com * http://www.loctite.com * http://www.humiseal.com Be aware that uV co
Electronics Forum | Thu Nov 23 23:59:25 EST 2000 | terry sun
Hello to all out there, We're considering CC process,and would like to know some defferences between SSC3 of Electrolube and Humiseal 1B73, yes,I know that SSC3 is silicone one,and Humiseal 1B73 is solvent based acrylic as well as other basic propert
Electronics Forum | Fri Sep 11 12:08:10 EDT 2015 | derrikf
I built one using an old Asymtek Automove. When all was said and done, it cost less than $400, including what was paid for the machine itself. It's a very basic setup, (air over syringe), but for our needs it does everything and more. With air to syr
Electronics Forum | Sun Dec 26 23:48:01 EST 2010 | raghu
Dear Sir, We are using 1B31 conformal caoting of 48 sec viscosity in Zahn #1 cup, by machine(PVA354) application with Tank air pressure 2.3 psi, automising air pressure 1 psi. 7 days after application we are observing peeling off problem.. And n
Electronics Forum | Mon Jul 02 03:55:07 EDT 2012 | mccabekev
We are having a problem with inspection markings on our boards running when conformal coating is applied We have tried standard permanant markers, and also paint markers, but both run when the coating is applied. There must be someone out there who
