Electronics Forum | Tue Jan 13 16:40:03 EST 2004 | Jacob Lacourse
Hi folks, I have a conformal coating application where I need the coating to be UV stable for a number of years without any crazing or cracking of the coating. I have looked for such a coating and have come up empty handed. Much of the circuit boar
Electronics Forum | Tue Jan 13 19:55:09 EST 2004 | Tom B
Jacob, You might want to contact Mike Moninger at (941) 359-0933 @ Thermospray. http://www.thermospray.com
Electronics Forum | Thu Apr 16 10:13:32 EDT 2015 | charliedci
Anyone aware of an acrylic conformal coating that is UV curable?
Electronics Forum | Mon Apr 04 08:45:42 EDT 2005 | jimih280
how does polyurethane used for wood floor coating differ from urethane conformal coatings sold for circuit boards? where can i get uv tracer to put in oil based urethane?
Electronics Forum | Fri Apr 17 14:08:00 EDT 2015 | davef
Humiseal says, "UV cure – These materials are also more difficult to repair as they are the most chemically resistant and mechanically tough of all conformal coatings. Removal is possible locally by using powder abrasion."
Electronics Forum | Fri Apr 17 05:39:39 EDT 2015 | sarason
Electrolube has one. http://www.electrolube.com/products/conformal-coatings/uvcl/low_non-voc/ Sarason
Electronics Forum | Fri Jan 22 14:31:14 EST 1999 | Dave F
| I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the c
Electronics Forum | Sat Jan 23 07:08:54 EST 1999 | Graham Naisbitt
| I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the c
Electronics Forum | Wed Jan 27 09:00:56 EST 1999 | Chris Fontaine
| | I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the
Electronics Forum | Thu Mar 31 10:14:06 EST 2005 | davef
There's some nice low-VOC uV coatings out there. We don�t use uV cured coatings, but try: * http://www.emersoncuming.com * http://www.dymax.com * http://www.mgchemicals.com * http://www.loctite.com * http://www.humiseal.com Be aware that uV co
