Electronics Forum | Tue May 25 18:08:19 EDT 2021 | scarittagle
A certain degree of cleanliness is needed in SMT manufacturing environment but not as overkill as place it in a "clean room" environment... Yes, dust could cause defect on PCBAs (and there are research papers about it too) but onl
Electronics Forum | Thu Mar 02 18:15:01 EST 2000 | Stu Leech
How is the component marked. Is it ink marked, laser marked or what? What is the material that the marking on? What volume are you looking at? We used a small, pencil-sized sand blaster, loaded with bicarbonate of soda to errode the mark off of plast
Electronics Forum | Thu Mar 02 18:15:01 EST 2000 | Stu Leech
How is the component marked. Is it ink marked, laser marked or what? What is the material that the marking on? What volume are you looking at? We used a small, pencil-sized sand blaster, loaded with bicarbonate of soda to errode the mark off of plast
| 1 |
