Electronics Forum | Wed Sep 21 20:03:34 EDT 2005 | kevinbooth
I am going to agree with Rob a little. It is also possible that a internal ground plane might be under or connected to the pads of this cap thus causing a increase in temp to this part during reflow. This can cause parts on occasion to jump from the
Electronics Forum | Mon Apr 01 12:07:25 EST 2002 | slthomas
* What material are you using? Loctite 3609 * What is your cure profile? In excess of the 90-120 seconds at 150C that Loctite recommends. * Dot dimensions and tip? 27g. conical tipped needle for the 0603's. I started with a 14 mil dot which loo
Electronics Forum | Thu Oct 31 01:52:17 EST 2002 | jason
Anybody with experience on such a rework ?? The QFP has thermal pads underneath the body and needs to be re-connected when subjected for rework... Any ideas ???
Electronics Forum | Tue Jul 07 05:55:34 EDT 2009 | kpm135
I agree with your assessment of the two pins with irregular solder. The head-in-pillow or broken joint are both probable events for your defect. At this point in the process it will probably be difficult to pinpoint the exact cause. If it was a broke
Electronics Forum | Thu Jul 02 16:01:57 EDT 2009 | ewchong
thanks kpm. agree the cause of those pads lifting. all of them were no connects so they cannot be the cause of the electrical failure. when the bga was removed, all the solder balls on the pcb turned into conical shape due to the separation, except
Electronics Forum | Sat Jul 29 09:07:15 EDT 2006 | davef
The issue is not the gold, but the amount of gold. Gold content over 3 percent raises concerns about reliability of the solder connection.
Electronics Forum | Thu Jul 08 12:33:52 EDT 1999 | Mike Demos
Thank you all for your replies. Thanks to your replies and backup from the IPC-SM-782A (section 3.6.3.2) and James Blankenhorn's "SMT Design Rules & Standards," the designer has agreed to provide adequate clearance between the via and the pad. I wi
Electronics Forum | Tue Nov 20 20:58:43 EST 2001 | davef
Very coo!!! [You have done an outstanding job of describing your situation.] I guess the via are connected to a BIG chunk of copper that affects your profile on that pad / ball. At the same time, run a profile each on a: * Void pad * Nonvoid pad
Electronics Forum | Thu Jul 08 15:38:27 EDT 1999 | Earl Moon
| Thank you all for your replies. Thanks to your replies and backup from the IPC-SM-782A (section 3.6.3.2) and James Blankenhorn's "SMT Design Rules & Standards," the designer has agreed to provide adequate clearance between the via and the pad. |
Electronics Forum | Wed Sep 19 10:27:03 EDT 2012 | davef
My email mail machine couldn't send this to you ... Hi Stivais ... I didn't read the report. It seems to require downloading of a 'reader' of some sort. No thanks. If you would, just attach the report to this email. Regardless, energy-dispersive X-r
